For sale is a 1988 Polaris Trail Boss 250 Stator & Plate Assembly (W888127). It is in good condition and was removed from a running engine and tested. This will fit the 1988 trail boss 4x4 and 2x4.


I have Frames, Fenders, Racks & Tires for these for the models listed below. They are to large for me to ship but are for sale for local pickup. Let me know what you need and I can send pictures and price.

I deal mostly with Polaris ATVs from 1985-1999 but have some newer ones. I have parts off of over 75 ATVs and usually have over 15-25 complete units on hand that are awaiting disassembly. If there is something you are looking for let me know. 

If you feel that any part is not as described contact me right away and I can replace most parts with a different one.

 

 


Used Parts

The dictionary defines the word "used" as follows: "Not New, Previously Owned". With that being said, this is a "used" part. I will always do my best to make sure the parts that I sell are in good usable condition. I test all ATVs and all functions before I tear them down. If a part test bad and unusable it is thrown out. I also clean most parts so I can inspect before taking pictures and listing. I have no interest in selling you a part that you can't use, but you have to keep in mind this is a used part and may need to be cleaned or serviced in some way prior to re-installation. 

 ***Bearings, Bushings, Gaskets, Seals, Clutch Plates, Sprockets, Pistons, Rings, and Brake Pads are all considered "wear parts" and cannot be guaranteed unless specifically stated in the description that they are good***

.*ALL PARTS SHOULD BE INSTALLED BY AN EXPERIENCED MECHANIC - I will not be held responsible for part failure due to poor installation