6mm Radius 40mm Worktop & Breakfast Bar Straight Joints, Corner Joints & End Caps Axiom Linea, Artis Fireglaze & Original, Duropal Classic, Kronospan & Oasis.
630mm, 665mm, 670mm & 900mm Worktop/Breakfast Bar End Caps & Joining StripsThese metal joining trims from Design Hardware features a choice of black stove enamel, satin silver and chrome effect polished silver finish that coordinates with almost any kitchen. These trims reduces time and simplifies installation. corner trims are aluminium profiles 20mm wide that feature a profile matched curved designed to sit on the postformed edge of a worktop or breakfast bar and a 5mm lip to cover the end of the adjacent worksurface in a corner layout arrangement, they will cover any chipped edges within 5mm of the worktop or breakfast bar cut end. Each end of the trims are also profile matched to the work surface so they will fit either a left, or right hand installation, to accommodate worktop installations the appropriate end may need to be cut down with a hacksaw to the desired length. End trims are flat aluminium plates that cover the end of a worktop or breakfast bar run, they feature a curved top lip that sits on the top surface of the top approximately 2mm high covering any chipped edges within 5mm of the edge. Each end of the trims are profile matched so they will fit either a left or right hand installation. The corner joint will suit 38mm - 40mm thick worktops and breakfast bars that feature a 6mm radius to the top and bottom long edge profiles. Install using silicone to seal any raw work-surface edges to prevent water ingress, and secure the trim in place with countersunk wood screws at the hidden fixing locations. This corner cover trim will suit worktops and breakfast bars. This work-surface end trim will suit 38mm - 40mm thick, worktops and breakfast bars that feature a 6mm radius to the top and bottom long edge profiles. Install using silicone to seal any raw edges to prevent water ingress, and secure the trim in place with countersunk wood screws. The in-line joining strip will suit 38mm - 40mm thick worktops that feature a flat face with a 6mm radius to the top and bottom edge profile. This cover trim will suit worktops up to 900mm deep, smaller worktops will require the trim to be cut to the desired length using a hacksaw. Install using plenty of silicone to seal any raw ends of the worktop to prevent water ingress, and secure the trim in place with countersunk wood screws at the hidden fixing locations. These worktop and breakfast bar trims are supplied in single units without screws. Grab Yourself an eBay Bargain Order Now!. Any questions? why not contact us today |