This is a new revolution design full glue and
case friendly tempered glass cover for
Samsung galaxy s6 s7 s8 s9 s10 & s20 series
finger print ID scanner does not work S10e screen protectors
full glue means that the whole screen cover will adhere to the phone screen. not just the edges
case friendly means that phone can be used in a protective case without lose any sensitiveness
the world best real tempered glass protector
may have small gaps around edges to compensate use of a case
HD crystal clear
cleophobic coated
finger print resistant
liquid repellent
scratch resistant
ultra thin
super sensitive
dry and wet wipes
Important notice:
finger print ID scanner may not work with some screen protectors
Some screen protector may not cover 100% of the screen. There maybe a small gap
around the edges to compensate use of an edge overlapping case.
Before you apply this screen protector. please check this is the correct screen protector for your phone model. Measuring the screen protector against your phone screen to check for size. Check the screen protector thoroughly for any defects like hair line cracks; bubbles or any other defects. If you found any defects or not satisfied with the screen protector. Please do not apply the screen protector. Contact us immediately. Send us some clear photo evidence about the defects. We will exchange it for you.
It
is not an easy task to install this screen protector. It may look easy. But I
can assure you. It is not. Very carefully remove the inside plastic film
gently. Remove it hastily will peel off the adhesive glue. Causing bald batch
or spots. Often mistaken for bubbles. However incorrect installation will
result trapping bubbles. Because this has glue all over the screen. Once it
stuck down after first installation. Try to remove or adjust it can causing
damage to the screen protector. Try to smooth out the bubbles can also damaged
the screen protector. Thus you only have one try. Any mistakes will cause
damage to the screen protector. Damage occurred during the installation is not
covered by the manufacture’s warranty.
As
we can not be held responsible any damage to the screen protector during or
after the installation. We suggest you search the youtube for any helpful
instructions; tips and hints to ensure successful installation.
Top tip 1: if you are
having difficulty fitting the screen protector smoothly. Use a hot air hair
dryer to soften the screen protector. DO NOT set hot air hair dryer too hot or
too close to the screen protector. This is to avoiding the hot air hair dryer
melting or damage the screen Protector
Top tip 2: clean the
surface of the screen thoroughly. Give it time for the cleaning fluid vaporise.
Left over moisture and humidity can cause dampness on screen resulting the
screen protector not adhere properly. Use a hot air hairdryer can help to eliminate
dampness.
Top tip 3: we have tested pulling tab. The plastic film
can be removed safely. However if you find it difficult to remove the plastic film
by pulling the tab. try stick some sellotape to other corners or other areas of
the screen protector. Then peel off the film from there. NEVER try to remove
the film by force. It will crack; shatter or damage if removed forcefully.
Screen protector damaged under these circumstances will not be covered by the
manufacture’s warranty. Please contact
us if you encounter any difficulties.
We will not accept any negative comments as result of poor installations. If you are still not confident or sure about this. Please return the item to us within 14 days in its resalable conditions. We will refund you in full less initial postage cost. If you have any questions. Please do not hesitate to contact us. We are here to help anyway we can.
Thank
you