AR heater is designed for heating inlays and dental veneers to improve the flowability during bonding,preventing premature curing of the composite material and heating the resin, injection nozzle, anestheticetc.AR heater adopts the precision circuit to control its heating module,
and keep the temperature within ±1°C .Depending on the material and personal choice, the temperature canset to: 40°C, 45°C and 50°C .
Composition
1- Filter cover
2-Heating plate
3- Honeycomb heating barrel
4-Heating base
5-Indicator light
6-On/OFF
7-TEMP button
8-DC
9-Power adapter
Operation
1. Place the heating base on a flat tabletop
2. Plug in the power adapter, then press the button“On/Off”to start heating. (Default 40°C after power on).
3.After power on, single click“On/Off”to select the required heating temperature (40°C, 45°C, 50°C). The corresponding temperature indicator flashes during heating. When the indicator turns from flashing to ever bright, it means that it already reaches the required temperature. After that, it goes into insulation. Pleaserefer to Form 1 for details:
FORM 1
TenperatureI Indicator light color Heating Reach preset temperature
40°C White White LED flashing White LED is always on
45°C Green Green LED flashing Green LED is always on
50°C Blue Blue LED flashing Blue LED is always on
NOTE
1.Heating base and heating plate cannot be used as non-stick hybrid mats.
2. Avoid scratching the heating base and the bottom of heating plate while using.
3.To avoid cross contamination, do not use again the used heating base and heating plate before disinfection.
4.The heating base and heating plate must be thoroughly cleaned if the composite materialis stuck on it.
5.Do not use the power adapter that exceeds the applicable voltage
Cleaning and disinfection
AlI parts can be wiped clean with a cloth that dampens with disinfectant. Do not immerse any parts in anyliquid for cleaning and disinfection. It can not be autoclave sterilization.
Troubleshooting tips
3 indicators flash together Temperature control sensor failure
Technical parameters
Power adapter
Input: 100-240V AC 50/60Hz
Output: DC 12V 2A
Power: 24W
Temperature setting: 40±1°C , 45±1°C and50±1°C
Filter range: (light <500nm) can't pass through the filter cover
Warranty
1. One year warranty on all parts of this equipment. Man-made damage is not covered bv the warrantv period.
2.Do not disassemble the equipment to prevent electric shock after the failure occurs. Please return to dealers or manufacturer.
3. Do not dissemble the equipment for repair. Oherwise,it is not free during the arranty period.