BRAND NEW IN BOX
1 PAIR
30mm Hubcentric Wheel Spacers
5x114.3 with 60.1 centre bore
Designed to fit
vehicles with M12x1.5 studs
Please note you may need to cut your factory studs as the normal stud length is approx. 24mm
Most of the time you may well find that stud length may well sit inside the rear of a lot of wheel designs
As many wheels have a hollow or concave rear to the hub area
Please check this when fitting the spacer
PCD / BOLT PATTERN 5x114.3
CENTRE BORE SIZE 60.1mm
These wheel spacers are a great fit giving that Euro look to your car or for getting the offset correct on a pair of wheels
They are designed to fit directly onto your original wheel hub using the nuts supplied in the kit
The wheel is then attached to the spacer using your original nuts
The spacer has a centre bore to match the hub to ensure a perfect fit
This is a complete set (1 pair) of wheel spacers, If you need to do all 4 wheels you will need to buy 2 PAIRS
Fitting advice
Please ensure that you use a qualified fitter to have these put onto
your vehicle if you intend to use them for road use. We advise that you take
the item to your local M.O.T garage. or tyre technician to have them fitted and
advise them not to use an air gun and only tighten the studs/bolts between
70-90 Newton metres.
Although some of our products may seem simple to fit
we do always advice that you have them installed by a qualified fitter and wait
to receive the item before making arrangements for the fitting of the item. We
also advice that you contact your insurance company to ensure the modifications
you are planning to make to the vehicle does not void your policy. We can not
be held accountable if you are not a qualified fitter and you damage the item
in any way, if you have booked the fitting before receiving the item or if you
do not inform your insurance company of the modification and your insurance is
voided.