Input: USB
Capacity: 50 to 300cm2 EL Panels
– or 5 to 15m of EL Wire
Dimensions: 4 x 3.2 x 4cm
This EL Inverter is suitable for between 50 and 300 square cm of EL Panel or between 5 and 15 metres of EL Wire.
It has been in-filled with epoxy resin which keeps it water resistant as well as helping keep the whistle of transformer to a minimum.
There is a choice of either an On/Off Trigger Switch on a 1.2m long cord or if you choose ‘No Switch’ then it will come on when you attach it to a power source.
These EL Drivers are powered by any USB Port Or they can be powered by a rechargeable li-ion Battery that can be recharged using a USB port.
(Please be aware that the inverter should always be attached to some EL Wire, Tapes and Panels or when it has power to it, it will overheat.
The Inverter has USB port
Li-ion Battery
3000mAh (thin): (6.5cm x 5.5cm x 0.8cm)
Leads are both 9.5cm long
SPECS:
Capacity: 3000mAh
Input power: DC 5.2V
Output: DC 4.5V – 5.2V
Over-charge / discharge protection: Yes
(*Li-ion Batteries are only available to the UK due to airmail postal restrictions)
This and Many other EL products can be found in our EL Panel And Tape ebay store
Electroluminescent technology is low power and eco-friendly and used for all types of lighting projects.
They can also be trimmed if you need to create a particular size or shape.
Electroluminescent Panels are flexible and as thin as a laminated sheet of paper, less than 1/2mm, that glows on one side.
The technology has developed a lot since it was researched in the 1950s to be used in early radar monitors.
Now, EL Panels have proven to be robust and versatile and have many uses from backlighting displays, architectural highlights, theatrical props and safety lighting.