This is a dedicated EL Inverter so it is tweaked to perform best with EL Panel and tapes (though it can also drive up to 3m of EL Wire, but not as brightly as a multi-use inverter would)

These specialist inverters have been designed for use powering EL Panels in vehicles.

They are silent and also have an earth which helps remove any EM interference.

These Inverters are most useful for EL Panels in the scuff plate of doors, as well as ones that backlight dashboard displays

The Inverter has a 2.1/5.5mm jack plug built in (this is a standard 12v connector)

For the 12v version you will find these compatible Power Inputs options in the drop down selection:

Only Inverter

You may already have your own 12v input with a 2.1/5.5mm connector

12v Crocodile Clips

This is usually the solution if you want to run the inverter from your own 12v battery

Please note that rechargeable AA batteries are lower voltage than standard batteries so cannot really be used effectively with this battery box.

Li-ion Battery

These are smaller and lighter than the Battery Box, the 3000mAh Li-ion battery gives the same life as the 8xAA Battery Box with fresh alkaline batteries

1800mAh: 145g (5.6cm x 3.38m x 3.1cm)

3000mAh: 175g (7.3cm x 5.6cm x 2.2cm)

5000mAh: 250g (5.3cm x 5.8cm x 3.9cm)

All of these Li-ion Batteries come with an intelligent recharger

Mains Plug

This will convert mains electricity to 12v so it can be used as a handy input for this inverter

This and Many other EL products can be found in our EL Panel And Tape ebay store

Electroluminescent technology is low power and eco-friendly and used for all types of lighting projects.

The technology has developed a lot since it was researched in the 1950s to be used in early radar monitors.

EL Panels are flexible and as thin as a laminated sheet of paper, (less than 1/2mm), that glow on one side.

They can also be trimmed if you need to create a particular size or shape.