This kit includes:

All that is needed is a small screwdriver to attach the wires to the MP3 board. Add 8 x AA batteries and you are good to go!

You will also need a Micro USB Cable (not included) to load the sounds to your MP3 board. Alternatively, you can play them directly from a microSD card (not included) inserted into the board. If your computer doesn't have a MicroSD card reader/writer then this inexpensive microSD USB Reader and Writer will do.


Features of The FN-BC04-TB

  • High quality audio decoder which, supports MP3 and WAV audio formats.
  • Sampling rates supported: 8 / 11.025 / 12 / 16 / 22.05 / 24 / 32 / 44.1 / 48 (KHz).
  • 24 bit DAC output and supports dynamic range 90dB and SNR 85dB.
  • Supports one-on-one 4 button trigger control mode and RS232 serial port control mode.
  • In button control mode, it plays back 4 sounds one-on-one by negative triggering.
  • Uses microSD card and the built-in SPI flash memory as storage.
  • Built-in 4MB SPI flash memory by default.
  • Supports max. 32GB micro SD card.
  • Possible to load audio files to the flash memory directly via the micro USB port. Connecting to computer is similar to using a USB flash drive with PC.
  • Built-in mono 10 watt amplifier that can drive a 10 watt (8 ohm) speaker directly. Or  5 watt (if using 4 ohm speaker) 
  • Equipped with a 3.5mm audio jack for stereo output that can drive an earphone directly or to connect with an external amplifier.
  • Adjustable sound volume with the onboard potentiometer.
  • Wide range for power input (DC 8-24V).
  • PCB size: 52mmx49mm

Technical Parameters 

  • Working voltage: DC 8V-24V
  • Working current: ≤400mA (Input: DC12V)
  • Power Consumption: ≤10W
  • On-board flash memory size: 4MB
  • Audio format: MP3 and WAV

Connections

K1, K2, K3 and K4 are Normally Open (N.O.) manual buttons. TX port and RX port are used to connect with a MCU, through which serial commands are sent to control the module. 

Features of the speaker 

Magnesium/aluminum alloy concave cones and square frames are the distinguishing features of the BS Series. HiVi B2S 2" drivers are capable of covering a wide portion of the audio spectrum, and are easy to install without the need for cutting complicated driver recesses. Magnetically shielded design allows use in center channel and other multimedia applications. Stamped steel frame and rubber surround.

Speaker Product Specifications

  • Nominal Diameter: 2"

  • Power Handling (RMS): 10 Watts

  • Power Handling (max): 20 Watts

  • Impedance: 8 ohms

  • Frequency Response: 150 to 15,000 Hz

  • Sensitivity: 78 dB 2.83V/1m

  • Voice Coil Diameter: 1"

  • Sensitivity: 78 dB 2.83V/1m

Mounting Information

  • Overall Outside Diameter: 2.13"

  • Baffle Cutout Diameter: 1.875"

  • Depth: 1.25"

  • # Mounting Holes: 4

  • 4ft. of wire soldered to the speaker