eBay

ORCA HYPALON GLUE ADHESIVE 2 PART FOR INFLATABLE BOATS

Made in Belgium.

Orca adhesive is the #1 glue for Hypalon repairs.

THIS IS FOR HYPALON BOATS ONLY. IF your BOAT BUILT OF PVC FABRIC choose STABOND 2 PART GLUE INSTEAD .

2-Part Hypalon adhesive for repairing and gluing rubber pads,Handles,Hypalon patches onto inflatable boats, dinghies and life rafts including AB, Achilles, Avon, Caribe, Novurania,Zodiac(Hypalon type),Polaris etc.
Hypalon Adhesive to bond Hypalon to Hypalon, but this adhesive may also be used to bond other synthetic rubber materials, like neoprene and EDPM.
Includes: 250ml can of Adhesive, 15 ml bottle of Curative
Curing Time: Contact bonds in 10-15 minutes, full cure 48 hours
Single-part adhesives are good for temporary repairs. For a permanent repair with the maximum of strength, use the two-part products.

Instruction
Mix 5% hardener (treatment) to the glue before use. Maximum 10% hardener when in Cold Weather 10C-15C or High Humidity 50-75%. Do NOT exceed a mixture of 10% to the glue. M.E.K. is the thinner for PVC glue. If the glue hardens, you can add up to 10% MEK to the glue to reactivate the glue.

Glue mixed with hardener can be kept for up to 6 hours. Glue and hardener sealed in the bottles can be kept up to 3 years. We suggest to use a small painting brush to apply 1-3 layer(s) glue on both material surfaces. Wait 5 minutes between applications to allow glue to dry and then attach the two pieces of material together. Once you have applied the patch, work from the center out with something like a teaspoon to force out any air bubbles and then apply pressure to the repaired area for at least 24 hours. Wait 48 hours for the glue to cure before using.

PVC Glue can be used as one part. For a better result, please do 2 Part glue (glue and hardener) to ensure the overall quality of the repair and extend the life time of the bonding. For any repairs related to air leaks, please use 2 Part Glue.
Note: Suggested to apply the glue 1-2 layers on new fabric surface; 2-3 layers on old fabric surface; 3-4 layers for wood or plywood surface; 2-3 layers for parts or aluminum surface. (The surface of Hypalon boat fabric has a coating layer, sanding the boat fabric to get rid of this coating is a must before gluing.)
Only mix the amount of glue you require for the repair. Seal the bottle right away and store it in a cool area so that it may be used again. If the hardener turns to crystals or gets sticky, it is no longer usable. To clean the area that needs to be repaired, use Methyl Hydrate, Acetone or MEK.

Optimal Use

For the best results when gluing, the relative humidity should be less than 60% and ambient air temperature should be between 18C to 25C (65 F to 77F) and not in direct sunlight. Clean the patching area on the boat as well as the contact side of the patch, it is best to use M.E.K. (Methyl Ethel Ketone) patching solvent and cleaner. Keep solvent off skin. After applying the solvent, you will notice that the area will become tacky. This tackiness ensures good glue adhesion.