Description:
Help you to find the best position T antenna installation
IF signal strength meter
Built-in signal
Elegant exterior and convenient to carry
Excellent sensitivity
Specification:
Frequency Range:950-2150MHz
Input level Range:-40~-10dBm
Impedance:75Ω
Gain:≥10 dB
Power Supply:13-18V DC
Operating Temperature:0~40℃
Main function:
For the systems without automatic tuning capability
Connect your LNBF and receiver to the to trk the clearest setting for the you wish to tune to
Meter with LED displayer helps you know the strength of the signal cleanly
Meter with audio helps you to the antenna to signal. Audio signal gets louder at the best setting
Works with the multiple dish systems
Close or open the audio
With four steps gain for the signal, you can increase or decrease the gain of the meter
Operation:
1.Connect a jump cable from LNB to the astellite 's "" port. Connect the "Receiver" port, a DC 13-18V power which comes from the receiver.
2.Make sure that the is properly Plug in the cord and turn on the receiver
3.Set the dB to or 2 by ATTbutton, the signal LED will show from 15 to 30, then you can adjust the dish position, when you hear the and the value of signal strength getting more and more. It means you get the signal
4.Set the dB to be 3 or 4. adjust the dish again and again until the value of the signal strength is maximum, then you can see the LOCK light in the receiver, if the lock is lighting it shows you find the desired . Otherwise to adjust the dish again.
Pkage Includes:
1 piece Signal