Product Introduction:
- Operating Voltage:3-5V
- Standby Current:<5uA (3.6V)
- Recording Time:120s
- Recording Distance:1-5m
- Recording/Voice Play Mode:independently play a piece of sound recording or play a piece of prerecordig voice
- Cycle Mode Play:can set cycle play times or constant cycle play
- Prerecording voice is burnt from external to SPI Flash,can prerecord chord music or voice
- daptive Loudspeaker:8-32 ohm output power 4.5V 0.6W 8 ohm
- ecording Prompt:before recording one "BEEP",after finished,two "BEEP"
- Sampling Frequency:16KHz
You need to use it with those items together:
A speaker
A 2.5mm mono plug and microphone
Some 26 gauge or smaller wire
A soldering iron with a tip to solder cable that small.
2 spst buttons
A 3.5-4.5v power source
Description of speaker in the kit:
Dimensions: 20x4.3mm
AC Impedance: 8士15% Ω at 2000Hz
Rated Input Power: 0.8W
Max. input power: 1.0W
Resonance Frequency: 800士20%Hz
Output Sound Pressure Level: 93士3dB/0.1M0.1W at 0.8,1.0,1.2,1.5KHz Average
Frequency Response: Fo~ 15KHz
Operating Temperature: -20~+70 Celsius
Storage Temperature: -40~+80 Celsius
Key Recording Mode:
Everytime repeatedly record,it will clear previous voice data
- 1.RECL:level remains mode recording
- 2.RECE:single trigger mode recording
Key Play Mode:
- 1.PLAYL:level remains mode play,can connect with photoresistor,can play by light source control
- 2.PLAYE:single trigger mode play
Instruction:
1. Long press the recording button, then start recording after a "beep" sound. After the 120 seconds, there is double "beep, beep" sound, meaning the ending of the recording.
2. Press the play button to play your recording after all recording finished; Press the play button to stop playing when playing recording. (For key control or wired double button control modules)
Package Included (according to your choice):
- 1pcs x Recordable Voice Module Kit with battery case
- or 2 pcs x recordable boards only
6S recording module kits,pls buy it here. 30s Recording module set, pls buy it here.