Description
Lead Weather Slate Pipe Flashing
The perfect weatherproofing solution!
Suitable for flat roofs up to 20? and pitched roofs from 20? to 40? degrees with pipes ranging from 25mm to 160mm in diameter.
Made from a code 4 lead base with a durable rubber seal, this 450mm x 450mm slate will create a flexible watertight seal around flues and pipes providing essential weatherproofing for your roof whether it?s tiled, slated or even polycarbonate.
Features & Benefits
- Application ? available for both flat and pitched roofs up to 40?
- Protection ? watertight rubber seal protects against the weather
- Durability ? corrosion, stain and crack resistant
- Components ? code 4 lead base with flexible rubber seal
- Installation ? easy to install with only a few tools needed
Technical Information
| Measurement | Value |
|---|---|
| Lead Size | Length: 450mm Width: 450mm Height: 76mm |
| Rubber Collar Size | Diameter: mm Max Cut Size for Pipe: 160mm |
| Material | Code 4 Lead and Rubber |
| Compatibility | Flat Roofs (0-20?) Pitched Roofs (20-40?) |
Fitting and Usage
Fitting
- Measure the pipe or flue prior to installation to determine the correct size hole for the diameter, and then trim the rubber seal to that measurement using a sharp utility knife.
- Slide the flashing down the pipe using water as a lubricant if necessary.
- Place the upper edge of the lead base under your roof tiles and create an anti-capillary fold.
- Cut tabs in the bottom corners and press them under the tile to create a run off tray and then trim as required.
- Apply adhesive silicone for added strength and stability.