Usage:

2.1 After plug the power supply,the digital tube is always on ” -- ℃ ”

2.2 After plug the power supply,single press “ ON/OFF/SET ”

Heater goes into the heating state according to the set temperatue at previous power-off

.It automatically stops heating after reaching preset temperatue.

2.3 After plug the power supply,single press “ + ” or “ - ” into the setup mode.Press “ + ” can increase the preset temperatue.Press “ - ” can decrease the preset temperatue.After setting,single press “ ON/OFF/SET ” into the heating state.It automatically stops heating after reaching preset temperatue.

Notice:

In the setting mode,long press the “+”or “-” to quickly increase or decrease the preset temperatue,any integer within the preset temperatue 40-70 can be selected.

Feature:

1. Heater designed for heating composite resin material,improve the flow of its adhesive properties;At the same time it can also be used to heat adhesive when used manual equipment.

Heater use the precision circuit control module to heat,control the temperature tolerance within 1 degree,According to your choice of material and it can set any integer temperatue within 40-70℃

2. Some materials and recommended temperatue

Resin(for filling)：39℃

Resin(for bonding)：55℃

Branscan：38℃

Agar film：Melting 99℃；Insulation 60℃

Sodium hypochlorite：60℃