FINERFILTERS 4 STAGE UNPUMPED DRINKING WATER REVERSE OSMOSIS SYSTEM - 50 GPD
FITS UNDER YOUR KITCHEN SINK

Reverse Osmosis is a technology that is used to remove the large majority (98%+) of contaminants from water. 
The Reverse Osmosis system works by pushing the water under pressure through a number of increasingly smaller filters and finally through a semipermeable membrane, essentially trapping all contaminants.

This system produces up to 190 litres per day of purified water and comes complete with:

  • A 3-US gallon pressurised storage tank holding 6.5 litres of RO-filtered water.
  • Installation Manual.
  • Chrome Faucet Tap.
  • All pipes, pre-filters, post-filters, and fittings required for easy installation.

The membrane can last between 1 and 2 years dependent on water hardness. Filters are to be replaced every six months.

 

Please note: 

  • This system requires a minimum of 45 PSI (3 BAR) to work. 
  • Ideal pressure depends upon incoming water temperature but around 60 PSI (4 BAR) is acceptable.
  • If you have lower pressure you will likely require a booster pump or pumped RO system which can found here;

  • Diaphragm Booster Pump: - https://www.ebay.co.uk/itm/282823632329
  • Diaphragm Booster Pump & Kit: - https://www.ebay.co.uk/itm/282942142978
  • 5 Stage Pumped System: - https://www.ebay.co.uk/itm/334458552371
  • 6 Stage Pumped System: - https://www.ebay.co.uk/itm/334458552369
Reverse Osmosis Systems wastewater to make water, and this should be done at high pressure as the water is being forced through microscopic holes which catch contaminants. 

This is normal and the same with all RO systems as this is the way the membrane rejects the impure water, which goes to the drain, to produce pure water. The system works optimally at 80-90 PSI (5.5 – 6 bar), and to get to the quoted output, we’d recommend running the system on or around this pressure.

This allows the system to reduce the waste water to pure water ratio and work quicker at producing pure water.

As many people won’t have this main pressure; pumped RO Systems or booster pumps can be purchased from us and added to the system which will increase the pressure output (a minimum of 29 PSI (2 bar) is required to operate the booster pump).

The 4 stages of filtration are;

 

Stage 1
A 5 Micron Sediment Filter Made of 100% Pure Polypropylene Fibres. Removes Dirt, Sand and Rust.

Stage 2 
A Granular Activated Carbon Filter Composed of High-Performance Activated Carbon. Removes Free Chlorine, Odour, Organic Contaminants, Pesticides and Chemicals.

Stage 3
A Carbon Block Filter Composed of High-Performance Carbon. Removes Trihalomethanes, Pesticides, Volatile Organic Chemicals and 99.95% of Giardia and Cryptosporidium Cysts.

Stage 4
A High Rejection Thin Film Composite 50 GPD Reverse Osmosis Membrane with the Capacity to Produce up to 190 Litres of Purified Water per day. This Membrane Removes Contaminants Present in Water Including, up to 99% of Dissolved Salts, Lead, Copper, Barium, Bacterial By-Products, Oestrogen and Silica.

System Dimensions:

Length: 41cm

Width: 15cm

Height: 44cm

 

Tank:

Length / Width: 26cm

Height: 34cm

 

Approximate percentage (%) of contaminants removed by Reverse Osmosis.

 

Aluminium: 96 - 98

Lead: 95 - 98

Ammonium: 80 - 90

Magnesium: 93 - 98

Bacteria: 99+

Manganese: 96 - 98

Boron: 50 - 70

Mercury: 94 - 98

Bromide: 90 - 95

Nickel: 96 - 98

Cadmium: 93 - 97

Nitrate: 97 - 99

Calcium: 93 - 98

Phosphate: 95 - 98

Chlorine: 98+

Potassium: 92 - 96

Chloride: 92 - 95

Silica: 80 - 90

Chromate: 85 - 95

Silicate: 92 - 95

Copper: 96 - 98

Silver: 93 - 96

Cyanide: 85 - 95

Sodium: 92 - 98

Fluoride: 95 - 98

Sulphate: 96 - 98

Hardness: 93 - 97

Thiosulphate: 96 - 98

Iron: 96 - 98

Zinc: 96 - 98