V-Mar 16C Collet Stop

We have designed what we feel is the best 16C collet stop available. Most of the collet stops on the market use a threaded rod for the work piece to bottom against. This is very slow to adjust and expensive if you need to make different size stops. Our collet stop uses simple 3/8" rod. Easy to get and very cheap. Adjusting the stop is also very fast, just loosen the pinch bolts, slide the rod to the desired position and snug up the pinch bolts.

We chose to use Torx-Plus (IP30) bolts since these have the best fit, and are least likely to round or deform like an Allen head bolt. We assume these stops will be adjusted often, and the bolts being loosened and tightened many times, so we went with the best fasteners possible. An IP30 Torx-Plus bit is included. We suggest tightening the bolts to 8-10 ft/lbs. (96-120 in/lbs or 10.8-13.5Nm) using a torque wrench.

We offer the collet stop by itself if you want to make your own stop rod(s), or in a kit with 11 different size stops included. The stop rods are sized for 1/8", 3/16", 1/4", 5/16", 3/8". They are all approx 0.010" under the nominal dimension. So if you are locating a 1/4" work piece, the stop rod is 0.240" so the collet does not clamp onto the stop rod, it will insure that the collet clamps the work piece. The 2 smaller rods are aluminum. The 3/8" rod is Stainless Steel. On the opposite end from the 3/8 (0.365") end the rod is machined to a drill point angle, so the larger stop discs will bottom out securely. (This can be seen in the section view image) The larger stops that fit onto the SS rod are 1/2", 3/4", 1", 1-1/4", 1-3/8", and 1-1/2", and just like the rods, these are all slightly undersize, approx 0.010" - 0.020". (ie 0.490", 0.740", 0.990" etc)

NOTE: If the work piece is longer than the clamping section of the collet you can use any of the stops, the stepped down stop rods are only needed when the work piece is short and the stop rod needs to fit up into the clamping section of the collet. See the cutaway CAD diagram.

Made in the USA from 6061 aluminum, black anodized. The stop rods are aluminum and stainless steel, the larger stop discs are also black anodized aluminum.

Finally, we also offer the 16C Collet stop bundled with one of our 16C Collet Stop Extensions (choose 3", 6", or 12") which we also sell separately in a different listing.