SmartSolar Charge Controller MPPT 100/30 

• Battery voltage 12/24V Auto Select
• Rated charge current 30A
• Nominal PV power, 12V 1a,b) 440W
• Nominal PV power, 24V 1a,b) 880W
• Maximum PV open circuit voltage 100V
• Max. PV short circuit current 2) 35A
• Maximum efficiency 98%
• Self-consumption 12V: 30 mA 24V: 20 mA
• Charge voltage 'absorption' Default setting: 14,4V / 28,8V (adjustable)
• Charge voltage 'float' Default setting: 13,8V / 27,6V (adjustable)
• Charge algorithm multi-stage adaptive
• Temperature compensation -16 mV / °C resp. -32 mV / °C
• Protection
• PV reverse polarity
• Output short circuit
• Over temperature
• Operating temperature -30 to +60°C (full rated output up to 40°C)
• Humidity 95%, non-condensing
• Data communication port VE.Direct

Enclosure

• Colour Blue (RAL 5012)
• Power terminals 16 mm² / AWG6
• Protection category IP43 (electronic components), IP22 (connection area)
• Weight 1,3 kg
• Dimensions (h x w x d) 130 x 186 x 70 mm

Standards

Safety EN/IEC 62109-1, UL 1741, CSA C22.2
1a) If more PV power is connected, the controller will limit input power.
1b) The PV voltage must exceed Vbat + 5V for the controller to start.
Thereafter the minimum PV voltage is Vbat + 1V.
2) A PV array with a higher short circuit current may damage the controller

All cabling carefully design to minimise voltage drops and maintain maximum system efficiency. TUV Approved

Victron Energy Inverter Technical Specification

• 12 Volt
• Cont. power at 25°C (1) 1200VA
• Cont. power at 25°C / 40°C 1000 / 850W
• Peak power 2200W
• Output AC voltage / frequency (adjustable) 230VAC or 120VAC +/- 3% 50Hz or 60Hz +/- 0,1%
• Input voltage range 9,2 - 17V
• DC low shut down (adjustable) 9,3V
• Dynamic (load dependent) DC low shut down (fully configurable)
• DC low restart and alarm (adjustable) 10,9 V
• Battery charged detect (adjustable) 14,0V
• Max. efficiency 91%
• Zero-load power 6,5W
• Default zero-load power in ECO mode (default retry interval: 2,5 s, adjustable) 1
• ECO mode stop and start power setting Adjustable
• Protection (2) a - f
• Operating temperature range -40 to +65°C (fan assisted cooling) Derate 1,25% per °C above 40°C
• Humidity (non-condensing) max 95%

Enclosure

• Material & Colour Steel chassis and plastic cover (blue Ral 5012)
• Battery-connection Screw terminals
• Maximum cable cross-section 25 10mm² /AWG4
• Standard AC outlets UK (BS 1363)
• Protection category IP 21
• Weight 5.5 kg
• Dimensions (h x w x d, mm) 105 x 230 x 325

1. Nonlinear load, crest factor 3:1
2. Protection key: a) output short circuit b) overload c) battery voltage too high d) battery voltage too low e) temperature too high f) DC ripple too high

EnergieStor Lithium 100Ah Battery

Double the usable power compared to Lead Acid Batteries, half the battery weight and lasts up to 10X as long.

• Rated Capacity 100Ah
• Watt Hours Capacity (Wh) 1280
• Max Charge Current (Amps) 50A
• Max. Continuous Discharging Current, 1C (Amps) 100A,
• Max. Peak Discharging Current for only 3-5 Seconds, 2C (Amps) 200A,
• Weight Approx. 11.1Kg
• Height with Terminals (mm) 230,
• Nominal Voltage 12.8V
• Max Charge Voltage 14.6V,
• Discharge Cut Off Voltage 10.0V,
• PCB Protection Over-Charge, Over-Discharge, Overcurrent and Short Circuit, Operating Temperature Storage & Charging 0~45 deg C, Cycles 2000 cycles @100% complete discharge, 3000 cycles at 80% depth of discharge (DOD), 5000 cycles at 50% DOD