eBay

This listing is for a quality RULER FOOT with outside diameter

1/2" giving accurate 1/4" from needle to the edge at all times.

Medium shank "Medium-to-High Shank" Plus a set of 6

Echo Ring Clips sizes: 3/8", 1/2", 5/8", 3/4", 7/8" and 1".

These Echo Ring Clips are laser-cut from 5mm acrylic and laser-engraved on the back side to reduce parallax errors.

Picture shown is with "red" marking line and inch. However the product is engraved/etched by laser without colour. We recommend you to use water-based marking pen preferably in "red" or "pink" colour to colour the etched markings lines for better visibility.

Since the opening is cut slightly smaller than 1/2" to ensure the ring will not fall off, so if you find it difficult to push the ruler foot into the hole just use awl to open up a little bit wider as shown in the picture.

Use it on all ruler feet that has a 1/2" (12.7mm) outside diameter to do the echo size you need. The sizes denote the distance from the needle to the edge. Usually all ruler feet for both domestic sewing machines and all longarm or mid-arm quilting machines like Handi Quilter, Bernina, Innova, Nolting, Martelli, Juki, Janome, Q'nique, Babylock etc. etc. have 1/2" (12.7mm) outside diameter so just clip the echo ring onto the ruler foot.

Important: First loose the screw so that the foot drops gently on

the sandwich and then tighten the screw. Try to move the

sandwich freely by hand. If tight, then loosen the screw and

raise the foot just a little bit higher but not too much.

*High Heel Ruler Foot for quilting with thick rulers or

templates

*Free-motion foot is adjustable so you can raise or lower

the foot depending on the thickness of your

ruler/template or the thickness of the sandwich quilt.

Special design with two "U" shape recesses - one on the front for sit-down free motion quilting and the other one on the side for stand-up quilting on the frame for better visibility.

Medium shank fits Janome "high shank" machines MC5000, MC5700, MC6600, MC6700, MC7700, MC9000, MC10000, 10001, 11000, MC12000, MC14000 Horizon, MC15000 Horizon, MC8200QC, MC8900, MC8900QCPSE, MC9400QCP, MC9900 Memory Craft, S5 Skyline, Skyline S9 and Elna "high shank" machines 8006, 9006, CE20, 680 eXcellence, 730 eXcellence, 730PRO eXcellence, 760 eXcellence, 760PRO eXcellence, 780 eXcellence, 860 eXpressive, 900 eXpressive, 920 eXpressive etc. and Brother PC8500D, ULT2003D, VE2200, VM5100, VM6200D, VQ2, VQ2400, VQ3000 and Baby Lock BLAR, BLDY Destiny, BLDY2 Destiny II, BLJY Journey, BLTY Unity, ESG3 and Elna 720 eXcellence, 7300, 740 eXcellence, 8006, 9006, 9600, CE20, e9500

Note: When using 9mm machine, please set 3.5mm as centre of the needle.

Will also fit some low shank machines like Janome, Brother, Babylock etc. - please check with us if in doubt.

Listing and template services provided by inkFrog