I found that if you get an aftermarket exhaust that involved removing the servo you are left with the Healtech ESE-T03 (Exhaust Servo Eliminator) just dangling and the best you could do is zip tie it out the way.

Being concerned about the Healtech ESE-T03 unit being exposed to the elements (aswell as the connector which used to be protected in the servo housing) I designed up this enclosure.

This will allow protection for the Healtech ESE unit, connector and provide a mounting solution to the original servo housing bracket (btw figured holes at the bottom were good to prevent trapped moisture).

3D Printed in ASA