Super strong and robust mounts
Triple torx screws to h your scope firmly in place
Recoil Pin Stop
Rail 9-11mm
Internal cushion tape prevents marking and damage
High grade aluminium anodized in matte black
Configuration: 2 Piece
Ring Size (Diameter): 30mm
Height: High (17mm base to ring bottom)
Rail: 9-11mm
Fixings (Top Cap): Triple Torx Screw
Fixings (Rail): Double Hex Screw
Internal Cushion: YES
Retractable 'Recoil Stop' Pin: YES
Height: 52mm / 2″
Weight: 130g / 4.6oz
Fitting guidelines and clearance considerations
These mounts are for 9-11mm dovetail rails as typically found on air rifles and rimfire.
They are for 30mm scope tubes
They are a High profile with 17mm measured from base of mount to base of ring (Saddle) - This is a critical dimension when calculating clearance over the rifle body.
On a flat base will suit scopes with maximum *OUTER* objective case diameter of 63mm (63mm will give 1mm over flat body clearance)
Calculating scope to rifle body clearance
The way you calculate the clearance is by halving the overall OUTSIDE diameter of your rifle scopes objective lens and then deducting half the rifle scopes body tube diameter.
For scopes with a 30mm diameter body tube diameter this means deducting 15.
Note we say OUTSIDE diameter - this means NOT the lens diameter, you need to measure the whole outer casing diameter.
The result gives you the minimum "saddle" dimension required - the measure from base of mount to bottom of the ring.
The amount the saddle dimension is greater than the figure you have calculated is the amount of clearance your scopes objective will be clear of your rifles body. The saddle on these mounts is 17mm
Example -
Calculating your rifle scopes clearance in this way does assume your dovetail or base is not raised above or below your rifles barrel. Note some rifles with high or adjustable cheek pieces may require higher scope mounts or risers so that your eye is in line with the rifle scope and your head is kept in an upright comfortable position.