SILICONE PLUG TO FIT LED LIGHT OR BATTERY TEA LUGHT IN RESIN

Sent from Pacific Paradise Qld 4564 Australia

This very unique silicone piece has been created specifically as a 'plug' for a little LED light or battery operated tea light. The silicone plug is 18mm high and 36mm wide.

Place the silicone plug into your wet resin, once the resin has cured, remove the silicone plug and insert your LED light or battery operated tea light into the space. If using a tea light, remove the plastic 'flame' prior to insertion.

Please check the size of your light before purchasing the plug as it may be a different size.

NOTE: My silicone is heat resistant up to 120 degrees celscius (248 degrees fahrenheight). If you overheat the silicone using your torch, you WILL melt the silicone and it will stick to the resin. This is not a fault with my silicone, it is user error so please be careful using your heat gun or torch.