CAUTION: Some overseas sellers have copied or slightly altered this listing description and title. Those sellers are not offering the same service or item and are not selling from the UK so please be cautious of those if you are a UK buyer.

Display Stands for Small Lightweight Model Figures - Version 3 (V3)
Some minor assembly is required

Action Base Display Stand suitable for 1/144 HG/RG Gundam/Figure+Hook.
Suitable to SD, BB, 1/100, 1/144 Gundam, Saint Cloth Figures, some 6" figures etc.

This version 3 stand features a small circular base with more movable joints for greater options.
Some care and time needs to be taken to position the stand correctly for stability when in use with figures.
Small 3.75" figures may be displayed in a flight pose or models that may be slightly taller but light. 
The pole arms will need to be positioned suitably with a figure in the air also to find the centre of gravity to avoid it toppling over.

Please see all photos for stand details plus examples of figures in use with these actual stands (figures pictured range from 3.75" to 6")

Please Read: 
  • The pole sections will come assembled and not attached to the base
  • The waist/support arms section may require assembly which is a simple snap together procedure
  • The waist/support arms snap in going downwards in the holes. This then needs to be kept the same way up when attached to the pole joint
  • The waist/support arms can sometimes be quite tight to fit
  • When moving the support arms it is recommended to hold the section that snaps together between finger and thumb to try and avoid it popping out
  • If the support arms do pop out when moving as they are held in place by friction only you just need to pop it back in again, but please note some can be rather tight to get in due to first use so may require an adult
  • All parts are personally assembled and checked prior to sending
  • If the pole joints become loose they can be tightened due to the screw and bolt method on the joints. Don't go too tight though as you won't be able to move them and you may break something
  • The stand/s will be boxed for the post

*Not really suitable for large 6" heavy figures in flight poses, do so at your own risk*

NOT SUITABLE FOR CHILDREN
 
Stand Measurements:
  • Base width 4cm in diameter
  • Pole straight section (A) 2.5cm in length
  • Pole straight section (B) 4cm in length
  • Pole straight section (C) 4cm in length
  • Arm length fully extended roughly 15cm

Each buy it now is for x1 display base

*Official UK Seller - In stock and ready to post the next working day* 

There are No figures included!







































































-