Important: These badges are 3 dimensional and have edges, if driving above and beyond the speed limit, the laws of physics will apply to these edges and they may be ripped of by the excessive drag force. Consider buying vinyl stickers that have no resistance to the air if you think this may apply to you!

2 x Badge Set

These gel dome badges are high quality non-oem parts that includes a strong adhesive backing. They are slightly flexible, allowing them to fit to surfaces with slight curves, surface preparation wipes are included and they are supplied on a clear tape strip for easy fitting and accurate letter spacing. We recommend installing these away from areas that may come into contact or brushed continuously by clothing as overtime this may damage the badge.

Dimensions

Installation

Please read these instructions carefully before installing.  Failing to do so may result in the badge failing to bond as intended.

Tip: In cold conditions, pre heat the badges and surface before applying.

Good surface preparation is the key to a successful installation.  Ensuring that the surface is properly prepared is the responsibility of the installer.

Ensure surface is free from road dirt and is completely dry. We suggest applying a badge when the temperature is above 15°C, if the temperature is lower, you can gently heat the surface from a distance using a hair dryer.

Using a circular motion, thoroughly clean the surface with the enclosed surface preparation wipe for about 20 seconds, you may see the remaining dirt which was on the panel transfer onto the wipe.

If the surface has had waxes or silicon based products applied, further preparation will be required, we recommend using "spirit wipe" (not white spirit, this will make the surface greasy) or 99.9% isopropyl alcohol.  If there are traces of wax or silicon between the badge and surface, it will not fully bond.

Wait about 1 minute or until the solvent has fully evaporated and the surface is dry.

Remove the wax film from the back of the badge, position it onto the surface and firmly press all over for 10 seconds.

If any letters show signs of lifting, apply heat with a hairdryer, and firmly press and hold for 20-30 seconds.