eBay

2 Ton Heavy Duty Floor Jack, Lifting Range 5-1/8" to 13", Hydraulic Low Profile Trolley Service Car Jack, Blue(AA51)

🚗 Powerful and Reliable: This heavy-duty floor jack is a powerhouse, with a 2-ton (4,000 lb) load capacity. It's designed to handle a wide range of lifting tasks, from small cars to larger vehicles.

🏋️‍♂️ Impressive Lifting Range: With a minimum lifting height of just 5-1/8 inches and a maximum height of 13 inches, this hydraulic jack provides you with the flexibility to access tight spaces or lift your vehicle to a comfortable working height.

🏎️ Smooth Maneuverability: This floor jack is equipped with (2) large steel casters and (2) 360-degree swivel casters. This combination ensures smooth and easy maneuverability, making it a breeze to position and use.

🔩 Secure Contact: The large saddle surface area of this floor jack ensures better contact with the load you're lifting, providing stability and peace of mind during your lifting tasks.

🏢 Built to Last: Constructed with heavy-duty steel, this floor jack is built to withstand the test of time. It's a reliable companion for all your lifting needs, providing the stability and positioning you require.

🛡️ Safety First: Your safety is paramount. That's why this floor jack comes with a built-in safety valve, offering overload protection for worry-free lifting.

2 Ton Heavy Duty Floor Jack

Use only on hard, level surface capable of supporting the load.
Center load on saddle prior to lifting.
Support the vehicle with appropriate means immediately after lifting.
Do not move or dolly the vehicle while on the jack.
Lift only on areas of the vehicle as specified by the vehicle manufacturer.

Air Venting Procedures

With the jack in the fully lowered position, release valve open, remove oil filler plug.

Pump the handle rapidly several times. Reinstall oil filler plug.

Turn the handle/release valve clockwise to the closed position.

Pump the handle until the lift arm reaches maximum height and continue to pump several times to remove trapped air in the system.

Turn the handle/release valve counterclockwise in one full turn and lower lift arm to the lowest position. Use force on saddle if necessary.

Carefully and slowly loosen oil filler plug to release pressurized air.

Repeat above steps until trapped air is completely vented.


Assembly • If two piece handles are provided, assemble the upper section into the lower section, line up the holes, insert and tighten • Insert the bottom end of handle into handle fork and securely tighten the bolt and washer. Ensure the handle can turn freely.	Lifting • Turn the handle/release valve clockwise to the closed position. Do not over tighten. • Position the jack under the specified lift point. • Begin lifting by pumping the handle up and down. • Immediately after lifting, support the vehicle with appropriately rated jack stands. • Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jack stands.	Lowering Turn the handle/release valve clockwise to the closed position. Do not over tighten. • Pump the handle up and down to lift vehicle off jack stands. • Remove the jack stands. Do not get under or let anyone get under the vehicle while lowering. • Turn the handle/release valve slowly counterclockwise to lower the vehicle onto the ground.