3 ea - 4.5" OD x 1" Hub width x 3/8" Bolt Hole Cable Pulley Bracket

Includes:

3 ea. Stamped sheet metal mounting bracket - stamped from 1/8" thick steel sheet metal (Needs deburring and paint finish)

These brackets will mount pulleys that measure: 4.5" OD x 1" Hub width x 3/8" Bolt Hole

The bracket may be welded on.  Or, you may drill 1 or more holes into the bottom of bracket for bolting onto your application.  Bracket is unfinished, so it will need painting or powder coating as required.  The stamped bracket is RAW - meaning that the edges are rough mill finish just as they came out of the stamping press, and will need to be filled down to break sharp edges.

Bracket measures 4.375" wide x 5.062" High x 1.250" thick.  The 3/8" bolt hole to mount pulley is 2.813" from the base of the bracket to the center of the hole.  You can make a swivel pulley by drilling a single bolt hole in the center if the base.  Or, 2 holes can be drilled to mount it using 2 bolts.  Or, weld it in place and be done with it.  The half-round bracket profile nicely matches the radius of the pulley for an engineered,  high finished appearance.

These are typically used on high end exercise equipment, but they can be used for many other tasks where power transmission using a cable is needed.

Pulley/Bracket Combo is rated at more than 500 lbs at low RPM (less than 150 RPM)  The higher the RPM, the less the rating.

---