BROKEN - DAMAGED - AS IS - FOR PARTS - New, never used. Clearly, this unit sustained a major hit or drop during storage. This caused all of the screws to BREAK holding the cover over the impeller to the housing. The screws sheared with the threads still in the body (we have not attempted to extract). Additionally, the float switch is slightly bent. More concerning, we are not sure if the switch might now be compromised to water ingress. Lastly, the jacket and insulation on the cord is TORN, with the copper conductor exposed. We did test the motor to be in good working condition; it ran smoothly and quietly. The float switch did turn it on and off. At a minimum, you will need to reattach the impeller cover and repair/replace the cord, but it may need a new float switch.

Technical Specifications

• Submersible Sump Pump
• 1/2 HP
• Voltage 230V AC
• Single Phase
• 60 Hz
• Amps 4.7 A
• Vertical Float
• Off Point 3 in
• On Point 9-1/2 in
• Body Material Cast Iron
• Impeller Material Plastic
• Shaft Seal Material Carbon; Ceramic
• Flow Rate 72 gpm @ 5 Ft. of Head
• Flow Rate 61 gpm @ 10 Ft. of Head
• Flow Rate 45 gpm @ 15 Ft. of Head
• Flow Rate 25 gpm @ 20 Ft. of Head
• Maximum Head 23 ft
• Minimum Sump Pit Diameter 18 in
• Body Diameter 10-1/8 in
• Overall Height 12-1/16 in
• Discharge 1-1/2 in FNPT
• Maximum Diameter Solids 1/2 in
• Maximum Liquid Temperature 130 °F
• Thermal Protection
• 1,725 RPM
• Intermittent Duty
• SJOW Cord Length 15 ft (damaged)
• Gauge/Conductor 18/3

MSRP: $591.81