Old School high quality Phoenix Good Amp.

2 X 22 watts per channel (MPS-2220)

• Bridgeable

• TRI-LINEARTM output capability, stereo and bridged mono simultaneously set up is possible

• Adjustable Bass EQ 0 to +12dB

• Pulse Width Modulated (PWM) MOS-FET Switching Power Supply

• RIBBON-WINDINGTM of Power Toroid

• MS-250 is stable into 2 ohm loads MPS-2220 is stable into 1 ohm loads

• High-Current / High-Voltage Triple-Darlington Output Design

• 2-layer 20 mil thick GOLD-PLATED G-10 Glass-Epoxy Printed Circuit Board

• Variable input sensitivity 200mV to 2V

• Fuly muted turn-on/turn-off circuitry

• Floating/common ground switch

• Optically isolated input design

• Master/Slave "sync" connection

• Vi limiting circuitry with overcurrent LED

• Extensive burn-in and QC testing for the ultimate in reliability

2 •

Low RFI / EMI design

• MADE NI THE GOOD OL'USA

• Output Power per Channel- Both Channels Driven

MS-250

Into 4ohms @12V DC- 50 WRMS

Into 2 ohms @ 12V DC- 90 WRMS Bridged Power into 4 ohms- 180 WRMS

MPS-2220

Into 4ohms @12V DC-22 WRMS Into2ohms@12VDC- 4WRMS

Into 1Ohms @12V DC- 80 WRMS Bridged Power into 4ohms- 120 WRMS

•

THD at rated power 4ohms- 0.01%

• SMPTE at rated power 4 ohms- 0.03%

• DIM at rated power 4 ohms- 0.07%

• Frequency response- 15Hz to 20KHz +/-1dB

• Signal to Noise Ratio- > 100+ dB (20 to 20kHz)

• Input Sensitivity- 200mV to 2V

• OutputImpedance-2to16ohms

• Input Impedance- 10K ohms

• Idle Current- 2 Amps

• Current Consumption MS-250 / MPS-2220-

@4ohms stereo-15 amps / 7.5 amps @2ohmsstereo- 30amps/15amps

@1ohms stereo- /30 amps

@2ohms stereo, 4ohms mono- 35 amps / 18 amps

• Efficiency- > 80% (Power Supply)

• Damping Factor @(20 to 10Khz) - 1000 to 1

• Min to Max Voltage requirements- 10.2 to 15.5V DC

• Dimensions- 8.5" LX11.4" WX2.4" H