**NOT A PHONE**
Easy Keypad Repair Kit - Money Back Guarantee!
Watch the VIDEO below!
Panasonic KX-TGA410 membrane keypad
Membrane keypad fixes all your buttons
WHAT YOU NEED:
Small screwdrivers, Isopropyl Alcohol 70% (better 90%), rag/q-tips/old toothbrush
1) Disassemble your phone.
2) CRITICAL: Clean and dry the circuit board and rubber keypad using isopropyl alcohol. Rags, cotton balls or q-tips come in handy here. Make sure all the oils are removed before installation. The circuit board should not be sticky or slimy.
If necessary you can remove the rubber keypad and clean it in the sink using hot water. Just make sure it is completely dry before putting it back in the phone.
3) Peel the bottom brown liner off the spacer (side marked with red) and apply to the circuit board. Center the spacer as best you can. If not lined up properly the spacer can be removed and re-applied.
4) Remove the top brown liner from the spacer and stick down the black conductor layer writing side up. The conductor layer should be straight and flat after installation.
Make sure the black material does not contact any metal on the board or the microphone. Do not intentionally press down hard around the button areas causing indentations. It only needs to be tacked down enough to hold it in place. The rubber keypad will set and hold it in position permanently.
Expedited Shipping is sent First Class Mail in a bubble mailer envelope with delivery confirmation.
Priority Mail is shipped in a Flat Rate Envelope. Better tracking... slightly faster.