Honda Integra DC2 Type R Side Panel + Boot Tailgate + Centre Cap Stickers - Light Cars
Product
A replacement set of stickers for your Honda Integra DC2 Type R consisting of 2 x side panel, 1 x tailgate, 4 x centre cap, 1 x DOHC VTEC and 1 x ABS LSD stickers. ABS or LSD option also available, please specify at checkout. We offer these for both light and dark coloured cars so please check before purchasing. Correct colours and sizes using premium quality vinyl ensuring you receive the best aftermarket replacement stickers.
Shipping
All of our stickers are made to order so please allow up 48 hours to be shipped. Tracking option is available at checkout at an additional cost for most destinations. Typical shipping times can be seen below however please allow an extra 2 days in case of shipping delays:
UK = 1-2 workings days
Europe = 3-5 working days
RoW = 7-10 working days
Contact
If you have any issues with your order or have not received it within the stated timescales, please do not hesitate to message us directly and we will work with you to resolve any issues and concerns as quickly as possible. We pride ourselves on excellent customer service which is reflected in our feedback ratings.
Features and further details
- OEM style colours and sizes to ensure the best quality stickers.
- There is no background so the colour you choose is for the lettering only which is made up of precision layered vinyl.
- If you would like custom colours or sizes, please contact us with your requirements before placing your order.
Preparation and application
- If your sticker arrives in a mailing tube, it is recommended that you unroll the decal and let it lie flat, for at least an hour before applying.
- Before application, there may be air bubbles trapped which can occur during transit. To resolve this simply turn the decal over, face down and press/squeegee along the length of the decal. This will smooth out any air bubbles.
- Thoroughly clean the surface. It must be clean, dry and free of any dust or residue such as fresh polish or wax.
- Ideally, the surface and air temperature should be 10ºc or more. Use a hairdryer to achieve the surface temperature.
- After preparing surface, check that the sticker fits in place. If necessary, cut off any excess application & backing paper & make guidelines with masking tape or a non-permanent marker.
- If you have a large design, you can mix a very small amount of soap with water and spray on to the surface. This will help manoeuvre it into place.
- Carefully remove the backing paper. Ensure that no part of the design remains on the backing paper. Lie it face down and slowly peel the backing paper at a 180 degree angle.
- Position one edge of the sticker onto the prepared surface and slowly roll the sticker on, rubbing it down with the edge of your hand as you go.
- Using a credit card or something similar, squeegee from the middle to the outer edges.
- Slowly remove the application tape, ensuring that the sticker does not lift with the tape. We recommend that you leave the application tape on for 10 to 20 minutes before removing, this will ensure that the sticker will adhere to the surface fully.
- Air bubbles will usually disappear after a few weeks. If not, you use a pin to puncture the vinyl and squeeze the air out by pushing down with your thumb.
stickerdude.co.uk