1 Oak Grigsby 4 way Switch
2 CTS solid Brass bushings and shafts 250k pots
1 Mallory 150 Mustard Tone .047uf cap
1 Switchcraft input Jack
Premium push back wiring
This is a new range of CTS 250K pots that we are using. We measure all our pots before building your harness and guarantee that the pots are either 250k or higher (Once the harness is built, the Pots do drop a couple of K-Ohms) that's normal. If we find a pot under 250k, we discard it. Regular CTS Pots have a +/- 20% which means you could have a pot as low as 200k and anything below 250k starts to sound thin. The lower it is, the thinner it is.
In my Tele's, I use Mallory Caps, I prefer them to Orange Drops. The Mallory's are smoother and cleaner sounding than the Orange Drop.
This harness does NOT include the control plate. It is for display purposes only.
I also include a length of Gavitt yellow cloth backed push-back wire for the new ground wire.
I will send you a link to my wiring diagrams page, which includes two easy to read wiring diagrams and one enlarged blow-up image on where to add the new ground wire.
Position 1 - Bridge
Position 2 - Bridge & Neck
Position 3 - Neck
Position 4 - Bridge and neck in series (large fat tone)
I can also do it with 500k pots if you need it for a humbucker or stack Tele.