Supermicro SuperServer SYS-6024H-TRB Barebone 672042822560
Product SKUs

SYS-6024H-TRB
  • SuperServer 6024H-TRB (Black)
 
Motherboard
Super X6DHT-G
 
Processor/Cache
CPU
  • Dual 604-pin FC-mPGA4 Sockets
  • Supports up to two Intel® 64-bit Xeon® processor(s) of the same type below:
    • Xeon (Nocona) CPU with 1MB L2 Integrated Advanced Transfer Cache, up to 3.60 GHz
    • Xeon (Irwindale) CPU with 2MB L2 Integrated Advanced Transfer Cache, up to 3.80 GHz
    • Xeon LV (Low Voltage) CPU, up to 2.8 GHz
System Bus
  • 800 MHz system bus
Operating System Software
 
System Memory
Memory Capacity
  • Eight 184-pin DIMM sockets
  • Supports up to 16 GB DDR 333MHz memory, or
  • Supports up to 32 GB DDR 266MHz memory
  • Dual channel memory bus
  • Memory must be populated in pairs
  • Single-rank modules are recommended for 6+ DIMM support
Memory Type
  • DDR 333/266MHz buffered (registered) ECC SDRAM 72-bit, 184-pin gold-plated DIMMs
DIMM Sizes
  • 256 MB, 512 MB, 1GB, 2GB, 4GB**
Memory Voltage
  • 2.5 V only
Error Detection
  • Corrects single-bit errors
  • Detects double-bit errors (using ECC memory)
  • Supports Intel® x4 Single Device Data Correction (SDDC)
  • Memory Sparing / Mirroring
 
On-Board Devices
Chipset
  • Intel® E7520 chipset
  • MCH + 6300ESB + PXH/V +82541GI
SATA
  • Marvell® 88SX6081 8-port SATA Controller
  • RAID 0, 1, JBOD support
SATA
  • 6300ESB 2-port SATA Controller
  • RAID 0, 1, JBOD support
Zero Channel RAID
  • Support for Zero-Channel RAID
  • (Card not included)
IPMI
Network Controllers
  • 2x Intel® 82541GI Single Port Gigabit Controller
  • Supports 10BASE-T, 100BASE-TX, and 1000BASE-T, RJ45 output
Graphics
  • ATI Rage XL SVGA PCI video controller with 8MB of video memory
Super I/O
  • Winbond 83627HF chip
Clock Generator
  • CK409
 
Input / Output
Serial ATA
  • Ten Serial ATA ports
  • Up to ten SATA hard drives supported
  • 6300ESB - 2 SATA ports
  • Marvell 885X6081- 8 SATA ports
IDE
  • Dual EIDE channels support up to four UDMA IDE devices
  • Supports UDMA Mode 5, PIO Mode 4, and ATA/100
Floppy
  • 1 Floppy controller; 1.44 MB, 2.88 MB, 3-mode support
ZCR
  • Adaptec 2020SA (Card not included)
LAN
  • 2x RJ45 LAN port
USB
  • 2x USB rear ports
  • 2x USB internal headers
  • USB 2.0 Compliant / 1.1 Compliant
VGA
  • 1x VGA port
Keyboard / Mouse
  • PS/2 keyboard and mouse ports
Serial Ports
  • 2 Fast UART 16550 serial ports
Parallel Port
  • 1 ECP/EEP parallel port
  • 1 parallel port header
Chassis
Form Factor2U Rackmount
ModelSC823T-R500LP
 
Dimensions
Height3.5" (89mm)
Width16.8" (426mm)
Depth25.6" (650mm)
Gross Weight55.5 lbs (25.2kg)
Available ColorsBeige, Black
 
Front Panel
Buttons• Power On/Off button
• System Reset button
LEDs• Power LED
• Hard drive activity LED
• 2x Network activity LEDs
• System Overheat LED
• Power fail LED
Portsnone
 
Expansion Slots
  • 6x low-profile expansion slots
PCI-Express
  • 2 (x8) slot
PCI-X
  • 1x 64-bit 133MHz PCI-X (3.3V) slot
  • 2x 64-bit 100MHz PCI-X (3.3V) slots
PCI
  • 1x 32-bit 33MHz PCI (5V) slot
 
Drive Bays
Hot-swap6x 3.5" Hot-swap drive trays
Peripheral Bay(s)1x 5.25" full-height peripheral bay
 
Peripheral Drives
Floppy
  • Panasonic 3.5" 1.44MB Floppy Drive
CD-ROM
  • TEAC Slim 24x CD-ROM drive
 
SATA Backplane
1x 2U SATA backplane
 
System Cooling
Fans4x 80mm 6300 RPM fans
Cooling redundancy with fan shroud
 
Power Supply
500W (1 + 1) Redundant AC power supply with PFC
[ 24-pin, (8-pin, 4-pin)=12V) ]
AC Voltage• 100 - 240V, 50/60Hz, 10 Amp
DC Output• 5V + 3.3V ≤ 160W
• 12V Total ≤ 39 Amp
+5V30.0 amp
+5V standby2.0 amp
+12V115.0 amp
+12V215.0 amp
+12V318.0 amp
-12V1.0 amp
+3.3V21.0 amp
 
PC Health Monitoring
CPU
  • Monitors for CPU Cores, +1.8V, +3.3V, +5V, ±12V & +5V Standby
FAN
  • Four 4-pin fan headers
  • Four 3-pin fan headers
  • 8x fans with status tachometer monitoring
  • Status monitor for speed control
  • Status monitor for on/off control
  • Low noise fan speed control
  • Support 3-pin fans
  • Pulse Width Modulated (PWM) fan connector
Temperature
  • Monitoring for CPU, chassis environment
  • CPU thermal trip support
  • Thermal control for 8x fan connectors
  • PC temperature sensing logic
  • Thermal Monitor 2 (TM2) support
LED
  • CPU / System Overheat LED
  • Suspend-state indicator LED
Other Features
  • Chassis intrusion detection
  • Chassis intrusion header
  • SDDC
 
System BIOS
BIOS Type
  • 8Mb Flash EEPROM with Phoenix® BIOS
BIOS Features
  • Plug and Play (PnP)
  • DMI 2.3
  • PCI 2.2
  • ACPI 1.0
  • USB Keyboard support
Parts List - (Items Included)
 Part NumberQtyDescription
Motherboard / ChassisMBD-X6DHT-G-O
CSE-823T-R500LP(B)
1
1
Super X6DHT-G Motherboard
2U SC823T-R500LP Chassis (B = Black)
Air ShroudCSE-PT471Air Shroud
Cable(s)CBL-0049
CBL-0056
CBL0061
1
1
6
Front Panel LED Ribbon Cable
SATA LED Cable
SATA Cable
Fan(s)FAN-007046300 RPM Chassis Cooling Fan
Drive Bay(s)CSE-PT41(B)15.25" Drive Bay (B = Black)
Mounting RailsCSE-PT2512U Chassis Mounting Rails
Peripheral DrivesFPD-PNSC-02 (01)
CDM-TEAC-24(B)
1
1
Panasonic 3.5" 1.44MB Floppy Drive (01 = Black)
Slim 24x TEAC CD-ROM Drive (B = Black)
Power BackplaneCSE-PT822-PD50012U Power Distributor Backplane
Power SupplyPWS-00492SP502-2S 500W 2U power supply
SATACSE-PT17(B)
CSE-SATA-822
6
1
1" SATA drive tray
2U SATA Backplane
AS IS.