Diagbox v5.29 software for Citroen Lexia 3 Peugeot Planet 2000
Supplied on one DVD with full instructions v5.02 with updates to v5.29
The best version for clone dealer interfaces REV B that are un flashed/modified
Full dealer profiles are included for product activtion with instructions
Needs to be run on a laptop with Windows XP PRO 32-bit with Service Pack 3 installed
Will not work in Windows Vista, Windows 7 or Windows 8 running XP unless you dual boot with XP on the primary partition
Only v7.xx will work with these Windows versions and only 32-bit
This will not work with ELM327 interfaces
No cables or interface are supplied, software only
Service boxes and SEDRE are not included
For the following Cars
Citroen : C-ZERO, C1, C2, C3 DS3, C4, DS4, C5, C6, C8, C-CROSSER, NERO, BERLINGO, JUMPY, AX, SAXO, BX, ZX, XSARA, XANTIA, XM, EVASION, C15
Peugeot : ion, 107, 206, 207, 307, 308, RCZ, 407, 508, 607, 807, 1007, 3008, 4007, 5008, BIPPER, PARTNER, EXPERT, BOXER, 106, 205, 306, 309, 405, 406, 605, 806
You can do all as a authorized dealer does.This diagnostics software allows you to perform complete diagnostics of all from 1995 until present models. Diagnostics is performed via OBD-II connector (which is located near steering wheel) or via manufacturer-specific connector OBD I (only older cars, pre-2001).
This software performs ALL the functions like the original dealer software
The software supports K-Line multiplexor, CAN-BUS interfaces and SAE J1850 bus (both PWM and VPW).
The following functions are supported:
1.Read identification
Displays complete identification of control unit, e.g. part number, software/hardware version, manufacturer, etc...
2.Read fault codes
Displays all stored and pending fault codes with complete description
Program supports report printing or copy to clipboard.
3.Clear fault codes
This function clears all stored fault codes and other diagnostic information.
4.Auto-scan (complete car scan/test)
Detects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes.
5.Measured Values
Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Logging to file is also supported, which allows offline analysis.
6.Actuator test
Actuator test activates particular actuator (e.g. turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, etc..)
7.Programming functions/Adaptation
This feature is of great importance in all vehicles because systems like Engine control units, Immobilizers, Airbags, Alarms, Body Control Units, and some others, require you to perform reset or programming procedures after car repair is done, or even configuration after replacing broken Control Unit
If needed I have Diagbox v7.01 with a free update to v7.62
For original and REV C clone interfaces only
If you want you clone modified to work v7.xx I can do this for you
Should you want it instead of the v5.02-v5.29, please ask
I don't advise using v7.62 on a REV B clone interface, you do that at your own risk