* Highest Quality, Full Color, Anti-Slip Grip-Like Vinyl Sticker

* Will not Scratch, Fade (UV Resistant) or Peel

* Easy Install & Removal. No Sticky Mess Guaranteed

* Fits Sony PlayStation 3 Slim Console & Two(2) Dualshock Controllers

* Precision Cut, Easy Access for Buttons, Controls, & Connectors
* US Shipping

Install
1) Clean your PS3 Console and Controllers surface as thoroughly as possible. Use rubbing alcohol on a lint-free cloth to remove any grease or other contaminates. Most issues of non-sticking are due to some type of oil or grease that is on the unit PRIOR to installation.
2) Peel one piece of the Skin from the paper liner. NOT to let the adhesive side touch anything.
3) Determine the placement, apply the Skin to the surface using your fingers or the side of your thumb, starting from one corner and working your way across the surface.
4) If a decal sticker piece is not going on straight, you can gently lift the sticker back up. Do not stretch it from its original size.
5) If installed slowly and carefully, there should be NO air bubbles left under the sticker skin. Any air that may become trapped under the sticker skin during installation will go away in time. You can also use a pin to break it.
6) During the cold weather or for a better result, apply hot air to the decal surface to activate chemical agent after putting the sticker skin on your Console and Controllers. Especially heat up the edge surface. Allow at least 3 hours for cool down before touching the decal sticker skin. Using a hair dryer or hot air gun is fine.