12V led neon rope can be cut by every 3led.Please take a note that Max every 16.4ft (5m) 12v Blue led neon lights need to be connected to power supply to drive it,or there will be voltage drop 

 

According to the products you buy

+++Description+++

Type: Soft LED neon lights

Input voltage DC12V 

LED Chip Brand: Epistar

LED type: SMD 2835

LED quantity: 120leds/m

Super brightness

Waterproof: IP65

Size: 5/16" / 8mm

Color: Blue, Red, White, Warm White, Green, Yellow, Pink,Ice Blue

Cuttable Every 5cm (approximately 1.96") / 3 LEDs (At Marked) 

 

1. LED flexible neon rope light : what kind of place is flexible LED neon lights used ?

A: flexible LED neon lights are widely used in the building body adornment or landscape decoration, outdoor, indoor, bar, a ballroom, a senior entertainment and so on also can produce plastic advertising signs and lights.

2. flexible LED neon lights: what are the colors?

A: flexible LED neon lights can do red , yellow, blue, green, white, warm white, pink, orange, red + blue, blue + white, red green blue, also according to customer's requirement to match colors.

3. what material make it for Flexible LED neon lights?

A: flexible LED neon lights use the super bright import LED chips as the light source, energy conservation and environmental protection. Shell is using environmental protection PVC plastic material.

4. how much is Flexible LED neon lights can shear unit length ?

A: when in 12 V, red, yellow, orange , Blue, green, white, warm white is 5cm/3 leds unit. .

In the different voltage, voltage is the more lower , the shorter length of shear, at least shear length is 5 CM.

5. Flexible LED neon lights normal voltage? What ?

Answer: there are 220V AC,110VAC ,24VDC ,48VDC,12 VDC can choose.

6. Flexible LED neon lights work environment temperature?

A: flexible LED neon lights can be in negative 40 degrees, under temperature of 60 degrees normal use.

7. How to install flexible LED neon lights?

1. First fixed aluminum alloy rail on the place which need to installed

2. According to the length of requirements to splicing the length of light body well (must be cut in the place marked with shear mark )

3. Plug and tail part must inject a moderate amount of glass glue or silica gel, then put on rubber transparent casing, used the leaf blower shrinkage. (to glue dry rear can touch the water)

4. After straighten out light body into aluminum alloy orbit (not forcibly jerked back and inverse direction soft rub)

5. When the light body whole volumes in glue shaft please don't light on.