The exceptional technology
applied to the Funke ADSC-470 makes it possible to watch digital TV while you
are on the move. The digital antenna has been specially developed for the
automotive industry working to the highest quality standards.The Funke ADSC-470
offers the maximum digital TV reception in any situation.
the Funke ADSC410 is of a
compact and ultimate design in this technolody with its Ultra HD and HDTV
compatibility.
Please take
note of the following installation guidelines:
Make
sure that the antennas are separated from each other as far as possible. For
example, place one antenna at the front, and the other at the back of the
vehicle (see figure 1A and 1B). Or place one antenna at the left and the other
at the right side (see figure 2A and 2B).
Try
to keep the antenna as far away as possible from metal parts like the roof or
window frame of the vehicle.
Be
aware of installed window heating inside the front or rear window. Sometimes
very thin lines are present in the front window which act as a reflector and so
disturb a good reception. An often-good position to install the antenna, is
behind the mirror; this also enables you to easily arrange cables and module
behind the lining.
The
horizontal wires which are often present in the rear window, have less
influence on the reception.
A
good result is often achieved, while taking the window heating into account, by
placing the antenna in the middle of the front and rear window.
Because
the bonnet and tailboard of the car (depending on the type) can have a positive
or negative influence, it is recommended to experimentally determine if
mounting at the bottom or top of the window gives the best results. A higher
placed antenna is often better because there is less disturbance from
motorbikes or scooters.
It is
also possible to install the antennas inside spoilers, mirrors, sun covers,
head rests, always under the condition that you take the above statements into
account.
Be
aware that cables are installed so, that these cannot get damaged by vibration
or clamping. Fix all cables by using tie-wraps or something similar.
Make
sure that the connections at the receiver are well tightened and make good
electrical contact. Also make sure that a good earth connection is present at
the place where your receiver is installed. This is very important to ensure
trouble-free reception in an automotive environment.