In this kit you will get:

Tent - 1.2m x 1.2x x 2m

Light kit (Reflector, bulb and Digital ballast)

4" Fan kit - ST100 Fan 110m3/hr, Carbon Filter 4", 5m Alu Ducting - Please note this is a basic fan kit 

24hr Timer - Please select if required

YoYo - Please select if required

Fabric Pots - Please select if required

Media - Please select if required

Please see below for description on products:

Digital Ballast

Settings: 250w - 400w - 600w - 600wSL

Super Lumens - Boosts lumen output by 10% at the flip of the switch

Has “soft-start” program to allow multiple ballasts to start at the same time

Power factor of 99.9% - lose fewer watts from the power supply to the lamp

Runs on 120 to 240 volt power, 50 hertz or 60 hertz

Works with both Metal Halide (MH) and High Pressure Sodium (HPS) lamps

External breaker system protects against power surges

Low noise while in operation

Comes with an 2m power cord - Uk Plug

High Quality, 1-Year factory warranty

Fan Kit

FAN, ALUMINIUM DUCTING, CARBON FILTER, CLAMPS X 3

Air Flow

Centrifugal fan - 110 m3/h - comes with stand attached to screw to floor (can not see in picture)

Carbon Filter Size

To get the most out of your kit, please follow these few tips:

Remember, if you reverse-mount your Filter you will lose the benefit of your pre-filter and reduce the life of the carbon.

Always mount your filter as high as possible. Hot air naturally rises and so will your odours!

Try not to block too much of the filter with mounting straps or hanging devices. Use the ends of the filter to support, so not to inhibit the surface area of the filter.

Do Not mount your Filter near to humidifiers. Humid air over 85% may enter the filter rendering the activated carbon ineffective and your filter may NOT neutralise odours!

Ensure you have an airtight seal around the connection of your filter to ducting or extractor fan.