Descriptions:
1. Working Voltage: AC 85V-250V
2. Working Frequency: 433Mhz/433MHz
3. Receiving sensitivity: -105dBM
4. Max Load: 10A Relay ( have better load less than 5A)
5. PCB Size:75*58*15mm Case Size :95*62*29mm
6. Function: Limit & Wire External Button
7.
Original State OFF, (Suddenly, the electricity was cut off, then comes
again, the State still is OFF, you need manual turn it ON)
8. Out State: Momentary Latched Adjusted by the Jumper on the Receiver,
( we ship default as Latched, if you need use Momentary to change the
Jumper on the Receiver ,Notice, please don’t use Toggle)
9. Momentary----------Jumper on 1 Pin
10. Latched----------- Jumper on “L&S”
11. Momentary -------------
Press button"Up", the Motor Forward, Release is Stop.
Press Button "Down", the Motor Reverse, Release is Stop.
Latched----------------
Press button "Up", the Motor Forward, Press Button "Stop" is stop.
Press Button "Down", the Motor Reverse, Press Button "Stop" is stop
12. When the relay is activated, the buzzer synchronize with a “beep” prompt.
13.
When the receiver output state is “Latched”, we have set it 0.5s time
delay for forwards and reverse, it is the Protection function.
14.
We have made transmitter and receiver working together and test it
before ship it,when you get it don't need to do anything ,just install
it.
15. Learning Code :
(1) Press the learning button for 1 time,the learning indicator
flashes slowly,Then press the transmitter button up
16. Clear code :
Press the learning button on the receiver for 8-10s,the learning
indicator will flash 3 times and OFF , It mean all the transmitter code
in the receiver have been cleared.
Package:
1/2/3 X Remote Controller Transmitter (Include Battery)
1X 85V-110V 220V 10A 2CH Motor Switch Module