Product Specifications

Single Adjusting Jack Plate

Made of high strength polished Aircraft Quality Aluminum

Bronze and Brass hardware eliminate binding

Adjusts easily by turning one steel bolt

Offers 4 inches of adjustable Vertical movement

6 inches of setback

Weighs 27 lbs

225 Maximum Horsepower

Keep in mind that these characteristics can also be indications of other, more serious problems, but if you’re experiencing any or all of the above, your boat could be a good candidate for a jack plate implant!

• Poor Holeshot

• Your outboard’s not perpendicular (straight up & down) in relation to the water at top speed.

• If you can trim the engine all the way up without the prop letting go or with no appreciable loss of water pressure at full throttle.

• The hull doesn’t seem to “lift” like it should.

​

Here are the pre-drilled hole dimensions listed below in inches: 

• Pre-drilled holes for 1/2'' stainless hardware
• 12 7/8'' across the top two holes from center to center
• 9 7/8'' across the bottom two holes from center to center
• 8'' of vertical distance between the top holes and bottom mounting holes