Universal 433 MHz Electric Gate Remote Control Key Fob
4-Channel RF Wireless Remote Control Duplicator for Cars, Garage Doors, Gate Doors, Alarm Systems Heating Systems, Home automation e.g. Lighting and etc.etc.
This is a fixed frequency remote cloner (433mhz) for copying 99.99% common fixed and learning code remote controls.
Clone up to 4 remote signals from 4 different remotes!
Operating frequency: 433MHz
Remote control range: Up to 100 meter
Operation: 6V DC Battery CR2016 (2x 3V CR2016 Battery included)
With this replacement remote key, you can clone all 433.92MHz
Duplicate Your Existing Remote Controllers so you always have a backup:
1. Vehicle central locking systems
2. Garage doors
3. Electronic gates
4. Electrical appliances/Home automation i.e. lights
5. Car sunroofs
6. Car/Motorbike alarms
Note:
THIS ITEM IS NOT SUITABLE FOR CLONING ROLLING CODE REMOTES
Decoder IC: All learning code/fixed code. (All manufacturers)
Such As 2260（All manufacturers）、2262（All manufacturers）、PT2264、5326（All manufacturers）、SC5262、HT600、HT680、HT6207、HT6010、HT6012、HT6014、SMC918 series、527（All manufacturers）、1527（All manufacturers）、2240（All manufacturers）and so on.
PLEASE NOTE: Rolling code and special fixed code cannot be cloned.
If IC chips cannot match, it will not be copied, please verify the chip model before you buy.
We strongly suggest you check the IC CODE of your original remote key.
The replacement remote key may not work properly if you copy the code from an unsupported IC
Open the back shell of your original remote, to see the IC board
This copy of the remote control cannot copy a computer code and rolling code, the device can only copy fixed code or learn codes
Please replace the battery when the remote control distance is insufficient.
How To Program：
Step-1 Clear the history code from the duplicator
1. Press button A and B continuously until LED flash 3 times
2. Release button B (Keep pressing button A), and press button B Slowly for 3 times, LED flashes
3. Release button A, finish code clearance.
Check if clearance was done properly: Short press any button, the light won't flash at all.
If the light flashes when short press any button clearance process was done wrong. Please repeat the clearance process again.
Step-2 Copy code from the original transmitter
Place the cloner remote and the original remote close together back to back or side by side or end to end. Make sure they are touching.
1. Simultaneously press a button on your original remote and one of the buttons on the clone remote and hold until the LED on the clone remote flashes steadily.
The LED light will first flash 3 times quick, then stops for a second, then flashes steadily.
2. Release both buttons. Programming is successful.
Copy other buttons in the same way.