You are bidding on a 12 Volt 100% DIGITAL battery controller to prevent over-charging by simple dumping or cutting of incoming power. With EZ 5-point connection bar.
LONG LIFE digital model / 25 Million Cycles (75 Years+ service life)
Come with mounting flanges on both components
Our most versatile model is this 12 volt system that can be micro programmed by the operator to keep a 12 volt lead acid, gel, AGM, Li-ion, EB, etc.
Fine tune to your needs with the simple programming buttons.
(See video's - cut and paste the URL's into any web browser bar)
https://youtu.be/81y50tpSads
https://youtu.be/rVffRzl6zcY
https://www.youtube.com/watch?v=f9_P2rfQzgs
https://www.youtube.com/watch?v=f9_P2rfQzgs
https://www.youtube.com/watch?v=IZRahrogJ_A
https://www.youtube.com/watch?v=NZENiUNoHWo
WIND/SOLAR 24 VOLT 440 AMP DUMP / DISCONNECT CHARGE CONTROLLER
WITH BUILT IN DIGITAL DISPLAY AND INTELLIGENT DUAL PROCESSOR CONTROLLER
For solar panels and solar
IT CAN DISCONNECT THE INCOMING POWER
OR DIVERT IT TO A DUMP LOAD.
Max solar amperage in divert (dump) mode is 440 amps. This is a big hybrid wind and solar charge controller.
Use for wind or solar or both at the same time! Also use for hydroelectric or solar or both.
User changeable settings -- Several controllers on the market only let you set the dump level!
Connect multiple turbines and solar panels up to 440 amps worth at the same time!
Max continuous solar amperage in disconnect mode is 100 amps. REBUILT WITH NEW WIRING.
Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
You can connect both wind and solar at the same time. Reverse polarity protection
Ultra low power consumption even with the volt meter on (almost negligible). You can even set the volt meter to turn off after in-activity.
On board relay- Isolates electronics from back voltage spikes from large 440 amp relay.
This is important to get the longest life out of the electronics. No body else has this!
Dual (2) Microprocessor controlled -- Extremely stable and very accurate
Multiple user changeable settings, and trip points for many various system requirements and applications- You can change the dump point voltage level,
end of dump voltage level, length of time in divert mode when end dump point voltage is reached
Isolated Electronics Protection - Impossible to accidentally connect wind or solar directly to the circuit board.
High amp rating - 440 amps, 10,000 watts surge peak max.
Battery Status digital LED - Lets you know your battery's actual voltage in real time!
Green LED come on and then you know it's in dump mode or cut mode depending on how your relay lugs wired.
Plug and Play - Long leads for easy termination to your 12 volt battery or battery bank.
Battery regulator for both your wind and solar battery input power. This
regulator can either dump extra power creating free hot water or heat or
just cut off extra power to keep your batteries from over charging. This
unit is a must for wind turbine applications as it uses a mechanical
relay which can handle high voltage surges unlike solid state controllers.
If you use it as a DIVERSION or DUMP load MODE then it uses almost no power when it is NOT dumping (energy efficient sensing) In DISCONNECT mode it draws .2 amps but that's good since that means you have too much power in your batteries anyhow.
HOW POWER DRAW DYNAMICS WORKS:
If you use it as a DIVERSION or DUMP load MODE then it uses no power when it is NOT dumping (energy efficient sensing)