Permanently Repair Plasterboard Wall Patch

• Helps prevent repeat damage in high traffic areas
• This wall patch is ideal for creating a strong, permanent repair over holes, dents and other damage (that is less than 100mm in diameter).
• Metal reinforced patch helps prevent repeat damage in high traffic area
• Suitable for homes, workplaces, DIY, offices and tradesmen.
  
• Self adhesive fibreglass mesh with 100mm x 100mm (4'' x 4'') aluminum metal plate
• 2 pack of 10 x 10cm Repair patches.
  

Directions for use;

1. Lightly sand around hole and remove backing paper from wall patch.
2. Apply patching compound to metal side of wall patch and press firmly over the hole. The self-adhesive backing will stick to the wall or ceiling.
3. Cover entire patch area with compound, feathering the edges.
4. Allow to dry fully and sand to smooth out area.

Note;

    The mesh patch is self adhesive however more ABRASIVE SURFACES AND CEILINGS may require more glue or a small pin to hold the patch in place while applying filler.