1. GENERAL
The RU-C1 is a remote operation unit for the Hitachi FP-C1 and FP-C2 portable color cameras.
The RU-C1 is used when using the cameras as an EFP or studio camera.
2. INSTRUCTIONS FOR OPERATION
(1) The RU-C1 can be installed in the rack or
on the table. For rack-mounting, remove
the rubber feet, and for a desk-top use,
remove the rack mount brackets.
(2) When installing the RU-C1, note the
internal heat radiation. Especially when
using it on the table or floor, do not place
things on the RU-C1. If doing so, internal
heat radiation is prevented to raise the
internal temperature, which may cause
trouble.
(3) Use the specified camera cable only.
(4) Do not twist or fold the camera cable to
avoid damage to the cable wires.
(5) If the signal which is not synchronized
with the camera is fed to AUX, the out-
put signal may be interfered by the
input signal.
(6) A short-circuit protection circuit is built
in the power supply section of the
RU-C1. When the short-circuit protection
circuit is activated, turn off power.
Remove the cause of the short circuit,
and then turn on power. Since it takes
about 10 seconds to restore the short-
circuit protection circuit, turn on power
again ten seconds or more after turning
off power.