Svans hot water boiler SV5 12 volt pressureless/ open 0.5 bar.

Application: The SV5 is a Low pressure device /Open for operation with low-pressure fittings, or for operation with foot, hand or small pumps submersible pumps max 0.5 bar. When using a pressure pump, a low-pressure fitting must be used.

The hot water boiler for: motor homes, caravans, mobile homes, solar systems, camping, buses, commercial vehicles, gardens, yachts and boats. 

More information on our website:   www.Svans-Kiel.de

The device is small and compact and can be easily installed or integrated into existing water systems. The tank is fully insulated (foamed) to reduce heat and energy loss, the water stays warm for 24 hours after the device is switched off. (Like a thermos)

With full heating, two to three times the amount of hot water can be extracted by adding cold water, depending on the input temperature.

After switching on the device, hot water can be drawn off after 20 minutes. The plastic boiler, manufactured according to drinking water regulations, is vertical, the big advantage: the hot water collects at the top because of the large difference in height and does not mix with the inflowing cold water. It can be used down to the last drop of hot water. 

Functionality:

After pressing the temperature switch on the front, it lights up red (device is in operation) until the set temperature is reached via the temperature controller, then the indicator light goes out and the device switches off although the temperature switch is switched on. (The set temperature is achieved) As long as the temperature switch remains switched on, the device will maintain the set temperature, and the heating element is only switched on briefly. Visible on the indicator light, which then lights up again for a short time. The power consumption is then around 0.5 - 0.8 A/h at a set 65° (ECO position)/depending on the ambient temperature.

Security:

-The temperature switch and the associated probe switch off the device at a maximum temperature of 85°C. If this system fails, a second separate system steps in, a temperature fuse and the associated temperature sensor switch off the entire device at 92°C. (the second system is purely mechanical and requires no electricity.)

-Due to the boiler being installed vertically with the connections at the top, no water can leak out in the event of damage to the installation and thus lead to the boiler overheating.

Technical specifications: 

- Depressurized/open Max 0.5 bar

-Volume 5 liters 

-Voltage 12 volts (voltage range 10.0 volts - 14.6 volts)

-Power: (3 variants) 100 watts / 150 watts / 200 watts

-Temperature range 20-85C° adjustable

-7 degrees frost protection position

-Easy container emptying

-Dimensions HxWxD 440 x 285 x 180 mm. 

-6 point attachment

-Heating time: approx./ 200W 1.5 hours / 150W 2.5 hrs / 100W 3.5 hours (depending on the water input temperature and voltage. (max 14.6 volts)