Car Tint Film Van Limo Window Tinting Auto vehicle Scratch Resistant VLT 75%

This is one of our professional ranges of window films that consist of 2ply;  the film is thicker than the popular low quality cheap films sold in the market which tends to fade after few month. This is a higher-end quality film that will not fade; life span of the film is between 3-5years

• Window Film 2x P
• Anti-Scratch/Scratch resistant coating
• Different Size

Dyed Film

This type of window tinting relies on the absorbing properties of the dye to keep your car cool. Because it does not contain any metal it gives your automobile the blackest look and does not have any "sheen" to it. This film rejects the least amount of heat and is mainly used for its appearance. It does reduce glare, and reduces fading to interior upholstery.

Advantages:
1. Reject ultraviolet: Ultraviolet light can cause skin burns, skin cancer and fading, window films can block up to 99% ultraviolet whilst significantly reducing heat.
2. Enhanced security: this will also increase privacy making it unattractive for thieves.
3. Protect human safety: can provide a minimal level of protection in case of breakage; this is because the film will hold the pieces of glasses together.
4. Reduce solar heat: can significantly reduce the inside temperature of a vehicle; this will extend the life of A/C systems and reduce energy costs.

Instructions

1. clean the surface with appropriate before installation spray some soapy or detergent onto the glass and clean it thoroughly, taking special attention        to the edges. Making sure spots,dirt,grease and residue are properly remove and resisting dirt such as dry paint found on the glassafter successful        cleaning please use an appropriate cloth to dry the glass surface leaving not traces of water . 

2. Using a tape mesure take some measurment of the window and write it down. Cut the film to the shape of slightly 1" larger than the actual size of          the  window surface being covered 

3. Use two pieces of adhesive tapes to separate the film from its protective liner backing whilst removing the backing of the film spray some soapy               water onto the adhesive surface of the firm. 

4. Spraye water on both the glass window and window fim then place the film ( Adhesive side facing the glass) onto the window being careful not to            crease the film adjust accordingly to cover the window glass surface perfectly. 

5. Use a small squeegee to burnish the film onto the window and pushing air bubbles to the edges with the help of squeegee star to remove someof 

    the water from behind the film start from the centre moving outwards . Do not worry if you have not managed to get rid of all the existing water. This        stage is to keep the film in place for cutting. 

6. Trim the edges of the film with a sharp utility knife to reach  a perfect fit to remove any remaining water spray more soap water over the film then             appyl minimal pressure using the squeegee to push the bubbles out repeat until all air bubbles are completely removed.