Welcome to EB-TOOLS-PRO Buy from EB-TOOLS-PRO and you will receive fast free shipping and 24/7 technical support. I have been selling on eBay since 2008 with a 100% positive feedback so you can buy with confidence when you buy from EB-TOOLS-PRO.

Steck 21960 Self-Piercing Rivet insertion Tool and Steck 21970 Self-Piercing Rivet Extraction Tool.

No need for expensive hydraulic tools to remove and insert self-piercing rivets. Steck’s new SPR Insertion Tool is a high-grade, hardened steel frame, that uses a 1/2” 20 grade 8 hex bolt, with a magnetic end and center recess to hold the replacement SPR, while inserting it with your 3/4” or 19mm socket using your 1/2” impact wrench. 1) Technician locates a spot on the flange area, next to the SPR you just removed (after you have replaced the door skin or quarter panel. 2) Insert the new SPR on the magnetic end of the bolt, hand tighten to the flange area keeping the body of the tool against the door flange. 3) Install your 3/4” or 19mm socket on your 1/2” impact wrench and engage. Within 3-5 seconds you will see the bottom of the screw flush with the door flange. 4) Replace the required SPR’s and re-install trim panel according to manufacturer procedures. Steck 21970 Self-Piercing Rivets Extraction Tool No need for expensive hydraulic tools to remove and insert self-piercing rivets. Steck’s new SPR Extraction Tool is a high-grade, hardened steel frame, that uses a 1/2” 20 grade 8 hex bolt, with hardened tip, to easily push out a SPR with your 3/4” or 19mm socket using your 1/2” impact wrench. The SPR Extraction Tool allows the technician to control the repair process without waiting in line for the very expensive hydraulic tools to do the same process. 1) Follow manufacturer procedures to remove the trim panel which exposes the SPR’s that need to be removed. 2) Insert the hardened tip of the hex bolt to the inside of the door, hand tighten the bolt to the center of the SPR backside, keeping the body of the tool against the door flange 3) Install your 3/4” or 19mm socket to your 1/2” impact wrench and engage. 4) Within 3-5 seconds you will see the old SPR come out from the bottom.