Specifications:
1) Thickness: 2" / 50mm
2) Vehicle Bolt Pattern(PCD): 5x4.5" / 5x114.3mm
3) Wheel Bolt Pattern(PCD): 5x4.5" / 5x114.3mm
4) Hub Diameter: 82.5mm / 3.25"
5) Thread Size: 1/2"x20
Note:Please make sure you take the proper neasurements gefore purchasing
Package include: 4Pcs Wheel Spacers Adapters
What should I pay attention to during installation?
1) Check to make sure that the wheel spacer fits perfectly with the hub/axle stub and the inner mounting surface of the wheel.
2) Make sure that the wheel bolts being used are of the appropriate length, not too long or too short.
3) DO NOT proceed if both of the wheel spacer do not fit.
4) Please be sure to clean the rust on the hub before starting the installation, otherwise it will affect the working life of the spacers.
5) Make sure that you get 5-7 FULL TURNS of the lugs when installing. Torque them down to the manufacturers specs (up to and not greater than 110ft lbs).
6) Avoid using an impact wrench because improper usage may cause the lug nuts/bolts to break or loosen while driving causing a potential injury or accident.
7) All lug nuts, bolts and torque must be checked after driving the first 50 miles after installation. Afterwards, please check all lug nuts and bolts every 3,000-5,000 miles.
8) Alignment is necessary after installation, this will prevent any wobble and vibration from occurring.
How to measure the fender gap to choose suitable thickness?
1) Line up a straight edge ruler against the sidewall of the tire, use the measuring device to measure from the inside of the ruler to the inner fender lip.
2) Please take multiple measurements and use the smallest data point.(The most closest spot may be at the front or rear edge of the fender). The maximum recommended spacer
thickness= the smallest gap - 3/8"(10mm)
About the wheel bolts:
Your Factory wheel studs may extend past the surface of the wheel spacers. In this case you will need to:
1) Shorten the factory studs.
2) The wheels need to have the open slots (cavities) between mounting holes.
3) Purchase a set of shorter studs and replace them with the factory studs.
Vehicle Fitment Information:
Ford:
Ford Crown Victoria 1992-2011
Ford Edge 2007-2013
Ford Explorer 1991-2010
Ford Fairlane 1955-1967
Ford Falcon 1963-1970
Ford Galaxie 500 1967-1974
Ford Galaxie 1960-1967
Ford Mustang 1964-1968&1994-2014
Ford Ranger 1983-2011
Ford Taurus 2010-2014
Jeep:
Jeep Cherokee 1984-2001
Jeep Comanche 1986-1992
Jeep Grand Cherokee 1993-1998
Jeep Liberty 2006-2012
Jeep Wrangler 1987-1995&1997-2006
Lincoln:
Lincoln Aviator 2003-2005
Lincoln MKX 2007-2013
Lincoln Town Car 1991-2011
Mercury:
Mercury Cougar 1967-1973
Mercury Grand Marquis 1992-2011
Mercury Marauder 2003-2004
Mercury Mountaineer 1999-2010
Before & After