IMPORTANT! This set allows you to build GRIM GUARD LIGHT TANK WITH CREW.

Main weapons can be magnetized via 5x1mm magnets

Sponson weapons can be magnetized via 2 x 3x1mm magnets.

The turret can be magnetized to the hull via 10x2mm magnets.

The antenna is also can be magnetized and has an option to be printed fully. There's also a part where a 1,5mm² electrical wire can be inserted (1,38mm diameter)

Sponson weapons are compatible with front-hull weapons.

HQ resin miniature in 40k Heroic scale with 25mm bases.
The miniatures require painting and assembly (use cyanoacrylate superglue only).

WE NEVER COMPROMISE ON QUALITY

- 8K ultra-high resolution 3D printing with the market-top printers guarantees the highest possible print quality for today;
- The best UV printing resin maximizes the survival of models even after falling off the table;
- Careful manual parts positioning by our experienced specialists provide sharp printing with a minimum of the supports and makes post-processing fun and easy;

PREPARATION

1. Check

Firstly, check out all the details whether there are no missing or miscast parts.
If you have problems with details - please contact us.

2. Supports & touchpoints

We sell our 3D printed models without any major supports, but you should remove small touchpoints and ultra-tiny supports left on the model.
Please use a model knife and fine sandpaper.
Don't be intimidated by the process, we use a top-quality UV printing resin and it is very easy to work with.

3. Warped Parts and Repositioning

Sometimes thinner parts could be slightly bent or twisted.
You can easily fix that by immersing the piece in hot water or by applying heat from a hairdryer.
The piece should reform to its original shape by itself.
If not, gently twist the piece back into position.
The amount of heat that needs to be applied is often determined by the thickness of the parts. Thicker parts need to be heated for a longer time.
This technique can also be used to bend some parts into shapes and positions to pose models.

---