Thermal resin is not a normal plastic. It is a special plastic containing carbon. The thermal conductivity coefficient in normal plastic type is approximately 0.04 W/mK. (W/mK = The Thermal conductivity measurement unit.) The thermal conductivity coefficient of the carbon-containing thermal resin raw material used in the body of our product is 20W/mK. The thermal conductivity coefficient is 500 times higher than according to normal plastics. Due to the carbon content of the raw material, the thermal resin is smoked gray. Thanks to its high technology and heat conducting resin material, it does not accumulate the heat generated in LED`s. It quickly transfers to the environment it is in. Thus, LEDs work long-lasting. Due to the excessive heat seen in many plastic products, problems such as plastic deformation and burning of LED`s are observed. Thermal resin material is resistant to salt water and corrosion that may occur in water. Underwater boat lights should create a pool of light that covers the full width of the transom. On an average boat, two lights will do. But if your boat has a wide beam or multiple outboards, you will need three or more lights. The first step is to decide where you want to mount your lights. The best mounting location is usually on the transom as low in the water as is possible. Also, separating the lights by at least three feet will give you the best light coverage across your transom. Next, use a template to check to make sure the lights fit and to mark the location of the power cord hole. IMPORTANT! Do NOT mark the location of the screw holes at this time. You will use the light itself to mark the screw hole location. Check inside of the boat to make sure there is room to feed the power cord through. You are also making sure you are not going to drill into anything important such as wiring or hoses. If in doubt, find a different location for your lights. If everything looks OK you can drill the hole for the power cord. Product Description
LED Colour White Colour Blue Colour Green Colour White Colour Blue Colour Watts 25W 25W 25W 64W 64W Lumen 2500 Lumen 1300 Lumen 1700 Lumen 9000 Lumen 3360 Lumen Volt 12 VDC 12 VDC 12 VDC 10-30 VDC 10-30 VDC Body Thermal Resin Body Thermal Resin Body Thermal Resin Body Aluminium Bronze Marine Body Aluminium Bronze Marine Body Underwater Boat Light Specification
High Thermal Conductivity Thermal Resin Body Technology
What is the Thermal Resin?
LED 48 Pcs 5730 High Power LED LED Degree 110° Volt 12VDC Current 12V 2.10A Watt 25W.
LED Colour / Lumen White 2500 lumen , Blue 1300 lumen IP Code IP68 CLASS III Body Material Thermal Resin Body Glass Impact resistant special glass Product Cable 2 mt. 2x1,5 RNF Marine Cable Boat Light Application Guide
Amperage | 2.1 Amps |
Lens Material | Polycarbonate |
Light Source Type LED | Voltage 12 Volts (DC) |
Color | Blue (1300 lumen) |
Wattage | 25 watts |
Country of Origin | Turkey |
Manufacturer Part Number | ALUWL402SM |
Specific Uses For Product | Boat Lights |
Item Weight | 10.5 ounces |
Auto Part Position | Bottom |
Special Features | Waterproof |
Vehicle Service Type | Boat |
Special Feature | Waterproof |
Package Dimensions | 5.2 x 5.16 x 2.8 inches |
Shipping
Returns and payment
FeedBack
For any questions, using eBay contact system