This TransTec®
electrical case connector seal for GM 4L60E, 4L80E, 4T80E, and Allison
1000/2000 series secures the electrical contact pins that connect the
internal wiring harness to the vehicle harness, keeping oil sealed in
and blocking contaminants out.
Installation is a snap! See diagram in gallery
1. Easily remove
the old seal by lifting the tab on the side internal harness and slide
the old seal out from the main harness connector.
2. Line up the guides in
the OD of the TransTec® electrical case connector seal and push into the
connector until it bottoms out and the tab locks in place.
This seals the external Wiring Harness Case Connector
Seals any oil in from the trans that might bypass the pins and drip,
and to protect the pins from water infiltration and resulting corrosion