Package include:
4 x 23HS2430B stepper motor (Dual Shaft) 425Oz-in,112mm Length
4 x CW5045 stepper motor driver
1 x 400W 36V/9.7A switching power supply
1 x Mach3 USB Motion Card STB4100 V2.1
1 x USB Cable
General Specification:
Step angle accuracy:+ - 5%(full step,not load)
Resistance accuracy: + - 10%
Inductance accuracy:+ - 20%
Temperature rise: 80deg Max(rated current,2 phase on)
Ambient temperature ----------—20deg ---- +50deg
Insulation resistance:100ohm Min,500VDC
Insultion Strength--------500VAC for one minute
Datasheet(23HS2430B,Front shaft 8mm dia and 21mm length,back shaft 8mm dia and 11mm length,425 oz-in or 28kg.cm holding torque)
Drawing:
Wiring:
Red: A+
Green: A-
Yellow: B+
Blue: B-
CW5045 high microstep stepper motor driver
Power supply
The supply voltage can work normally in between DC12V-50V, FMD2740C driver can use ordinary switch DC power supply, can also be used for transformer and the bridge rectifier and filter capacitor, capacitance desirable 2000U to 5000U. Note rectified voltage ripple crest does not exceed 50V.Recommended the user to use the 24V-32V DC supply , avoid the grid fluctuations over drive voltage operating range.
Note:
1, Wiring should pay attention to the power of positive and negative Do not be reversed;
2, In order to reduce costs, multiple drives can share a power supply. But it should improve the rated power and rated output current of the power and attention to cooling.
Shipping
Feedback
1.) we care about our valued customers,and will always try to help you,hope to establish long business with you.
2.) Pls give us the opportunity to resolve any problem, we understand the concerns and frustrations you might have,and will try our best to resolve the issues.
3.) Pls contact us by ebay message or email before leaving any negative feedback or opening any cases on the site,we will help you to resolve the problem,