1、Product
introduction
2、Product features
l Force-free
l No wiring
l Support single/double key
l Self-generated electricity,
no need to install batteries
l Free combination, multiple
switches can control the same electrical appliance; It is also possible to
control multiple appliances with one switch
l Wireless remote control,
simple and beautiful, convenient construction
l Waterproof design of the transmitter, wet hands can also touch the switch
3、The main technical indicators of self-generating switch
Product name |
Type 86 Self-generating switch |
Turn on the key number |
Single key, double key |
Power mode |
Kinetic energy self-generated electricity |
Product size |
86*86*15mm |
Waterproof function |
Waterproof and moisture-proof |
4、The main technical
indicators of the receiver
Product name |
receiver |
Operating voltage |
AC110~230V50/60Hz |
Rated current |
AC5A |
Standby power |
<0.15W |
Operating frequency |
433MHz |
Control elements |
relay |
Can be equipped with switches |
Available with 5 pcs |
Product size |
50*30*22mm |
5、Schematic diagram of
product wiring
The
receiver input terminal hole L is connected to the AC fire wire;N connection AC neutral line,The terminal hole L at the output of the receiver is
connected to the load live wire;N is
connected to the neutral line of the load,As
shown in the following figure。
6、Device installation instructions, operating instructions:
7.1 Pairing
The receiver is in a state
of freshly powered on,If the indicator is solid, it is pairing mode (no switch is saved),Press the corresponding
launch product indicator to flash once, that is, the code is successfully
matched,Up to 5 switches can be
used by analogy。You can also pair it yourself。When the receiver is equipped with 5
switches and a new switch is equipped, the first switch is automatically
replaced。
Attention:In the case of power,Long press the button for
3 seconds to enter the coding mode,If there is no pairing learning
within 10 seconds, the coding mode will be automatically ended。You can also press the
button on the receiver to end the coding,When the button is not coded, a short
press is on or off。
7.2 Clear the code
Press and hold the button on the receiver until the
indicator is solid and flash 3 times to clear all matching codes。
7.3 Default on-off
Normal use of this product home sudden power failure,Whether the receiver is
turned on when a call comes in can be set according to your preference。
① Setting the light state after the
power is off:Press the button on the
receiver briefly to light the light,and hold for 10 seconds without any
operation,Setup complete。
② After the power is off, the light off
status is set:Press the button on the
receiver briefly to turn off the light,and hold for 10 seconds without any
operation,Setup complete。
7、Schematic diagram of the
modification
The original switch
position before the modification is unreasonable or inconvenient to use,Too few quantities。As shown in the following
figure。
③
④ After modification,Just plug in the receiver
in front of the light,Add 2 self-generating switches to change dual control。As shown in the following
figure。
⑤
8、Staircase light installation
diagram
⑥ Improve the inconvenience caused by
the old-fashioned layout, so that both upstairs and downstairs can be opened
and closed。As shown in the following
figure。
9、Technical support contact
information
QQ:173400562